Sony STR-K750P Operating Instructions - Page 40

Remote Button Description (continued) Notes • Some functions explained in this section may not work depending on the model of the receiver. • The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described. • To activate the buttons with orange printing, press ALT first before pressing the buttons. • Press MAIN MENU on the remote before you use the V/v/B/b buttons for receiver operation. • Press TOP MENU/GUIDE or AV MENU on the remote before you use the remote to control the satellite tuner, VCR and DVD player. • The VIDEO3, TV/SAT, PHONO, AUX, MULTI CH, SOURCE, DIRECT, AAC BI-LING, SB DECODING, 12 and ON SCREEN functions are not available for set operation. Selecting the command mode of the remote Set the remote command mode using the USE MODE button and the remote command mode buttons. Selecting the command mode You can switch the command mode (AV1 or AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver. Press AV1 or AV2 while pressing down USE MODE. The indicator lights once (twice for AV2) , then the command mode switches. To check the command mode of the remote Press USE MODE. You can check the remote by the indicator. Mode AV1 AV2 Indicator lights once twice To reset the remote to factory settings Press =/1, AV =/1, and MASTER VOL - at the same time. The indicator lights 3 times, then goes off. Programming the remote You can program the remote to control nonSony components by changing the code. Once the control signals have been memorized, you can use those components as part of your system. Furthermore, you can also program the remote for Sony components that the remote is unable to control. Note that the remote can only control components that accept infrared wireless control signals. 1 Press AV ?/1 while pressing down USE MODE. The indicator lights. 2 Press the input selector button (including TV ?/1) for the component you want to control. For example, if you are going to control a CD player, press CD/SACD. 3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control. See the tables on pages 41-43 for information on the numeric code(s) corresponding to the component and the maker of the component (the first digit and the last two digits of the numeric code correspond to the category and the maker's code respectively.) 4 Press ENTER. Once the numeric code has been verified, the indicator slowly flashes twice and the remote automatically exits the programming mode. 40GB