Sony STR-K840P Operating Instructions (primary manual) - Page 33

Receiving Broadcasts Presetting radio stations 1 Press TUNER. The last received station is tuned in. 2 Tune in the station that you want to preset using Direct Tuning (page 31) or Automatic Tuning (page 32). 3 Press MEMORY. "MEMORY" appears in the display for a few seconds. Do steps 4 to 6 before "MEMORY" goes out. 4 Press SHIFT to select a memory page (A, B or C). Each time you press SHIFT, the letter "A", "B", or "C" appears in the display. 5 Press PRESET TUNING +* or PRESET TUNING -* to select a preset number. If "MEMORY" goes out before you press the preset number, start again from step 3. 6 Press MEMORY again to store the station. If "MEMORY" goes out before you can store the station, start again from step 3. 7 Repeat steps 2 to 6 to preset another station. * For models of area code CEL, CEK: PRESET/PTY SELECT + or PRESET/PTY SELECT -. To change a preset number to another station Do steps 1 to 6 to preset a new station to the number. Tuning to preset stations You can tune the preset stations by either of the following two ways. Scanning the preset stations 1 Press TUNER. The last received station is tuned in. 2 Press PRESET TUNING +* or PRESET TUNING -* repeatedly to select the preset station you want. Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows: nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N nC0˜...C2˜C1N * For models of area code CEL, CEK: PRESET/PTY SELECT + or PRESET/PTY SELECT -. Using the preset codes Use the supplied remote to perform the following operations. For details on the buttons used in this section, see pages 39-45 for remote RM-PP411 and pages 46-49 for remote RM-U306. 1 Press TUNER on the remote. The last received station is tuned in. 2 Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons. 33GB