Sony UNIONER580C7 Installation Guide (UNI-ONER/EP Series Install & Operati

Installation and Operation Instructions for the following unitized outdoor camera models:

UNI-ONER / EP SERIES

Outdoor High PoE Clear Dome

UNI-ONER580C7

Unitized SNC-ER580 pendant type, clear dome, with heater and blower

UNI-ONER550C7

Unitized SNC-ER550 pendant type, clear dome, with heater and blower

UNI-ONER520C7

Unitized SNC-ER520 pendant type, clear dome, with heater and blower

UNI-ONEP580C7

Unitized SNC-EP580 pendant type, clear dome, with heater and blower

UNI-ONEP550C7

Unitized SNC-EP550 pendant type, clear dome, with heater and blower

UNI-ONEP520C7

Unitized SNC-EP520 pendant type, clear dome, with heater and blower

Note:

To maximize power for the camera and heater option, the unit requires that you

calibrate the enclosure.

This calibration process is shown starting with instruction

block 18.

During calibration, the onboard processor intelligently determines the

maximum safe power output of the midspan, and ensures that the enclosure does

not exceed that limit.

Once calibration is complete the required values are stored in

permanent memory, with no additional calibration required.

Note:

Please note that to achieve the increased depth with the aspheric design for optimal

camera lens to capsule orientation, the capsule is slightly angled around the highest

section.

This creates a ”line’, visible to the naked eye, around the upper most section

of the capsule.

This “line” serves as the geometric center line used to insure proper

camera placement.

It is not typically seen by the camera.

However, this line maybe

visible in the camera image when camera’s above horizon tilt capability is used.

81-IN6712

06152012