Sub-Zero 601F 600 Series & 430 Panel Specifications - Page 5
Overlay Door, Panels
View all Sub-Zero 601F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
BUILT-IN REFRIGERATION PANEL REQUIREMENTS The overlay door panel assembly must be a minimum of 5/8" (16) thick and cannot exceed 50 lbs (23 kg). OVERLAY DOOR PANELS If you and your client have ordered an overlay design model, you will be adding panels to give the unit the custom Sub-Zero look. The overlay panel design option is available on all Built-In units except Models 648PRO and 648PROG. For exact door panel dimensions for Built-In overlay models, refer to the Overlay Panel Specifications on pages 24-25. The overlay design allows decorative panels to cover the door trim for a more seamless appearance that blends with the design of the room. To achieve this look, the most common way is to work with three panels-the decorative overlay panel, a 0.10" (3) spacer panel and a 1/4" (6) backer panel. Depending on your cabinet manufacturer, this could be one panel routed for different dimensions or, more likely, three different panels. Regardless of the physical construction of the panels (routing or three-panel assembly), you will need to follow the Overlay Panel Specifications on the following pages for exact sizing and panel placement to ensure a proper fit. Illustration 3 is a cross section view of the threepanel assembly showing placement of the door, drawer or grille trim. Illustration 4 shows a rear view of the three-panel assembly and critical dimensions, standard for all models. IMPORTANT NOTE: Keep in mind that the Sub-Zero door panels have the potential for hitting adjacent cabinets and/or countertops when they are opened. You need to be aware of your surrounding cabinetry and space limitations when using the overlay models. Refer to the fullscale illustrations at the end of this section. If you are using an overlay door panel with Model 611, 611G, 650 or 650G, it is necessary to rout a space for the unit's lower hinge plate so it does not strike the door panel. Refer to illustration 5. For Models 611, 611G, 650 and 650G, you will minimize the reveal between the bottom of the overlay door panel and the top of the overlay drawer panel. Refer to illustration 6. IMPORTANT NOTE: If you choose not to rout a space for the lower hinge plate, you can reduce the total height of the overlay panel (decorative panel only) by 1/2" (13). Do not exceed the overlay decorative panel dimensions for Models 611, 611G, 650 or 650G listed on page 24. If you try to make the reveal tighter between the door and drawer panels, the panels may hit when opening and closing, causing possible damage to the panels and the Sub-Zero unit. Spacer Panel .10" (3) Overlay Panel Overlay Panel Spacer Panel 1/4" (6) Backer Panel 5/16" (8) min 5/32" (4) Door / Drawer / 1/16" (2) Grille Trim Illus. 3 ~3/4" (19) Backer Panel .10" (3) 1/4" (6) Illus. 4 1/2" (13) 3/8" (10) Illus. 5 Overlay Panel 1/4"(6) Backer Panel Spacer Panel 3" (76) Bottom Edge - Hinge Side (rear view) Overlay Panel 27/32" (21) Illus. 6 Spacer Panel Backer Panel 5/16" (8) 17/32" (13) 22