Symphonic ST191B Owner's Manual

Symphonic ST191B Manual

Get Symphonic ST191B PDF manuals and user guides View all Symphonic ST191B manuals
Add to My Manuals
Save this manual to your list of manuals

Symphonic ST191B manual content summary:

  • Symphonic ST191B | Owner's Manual - Page 1
    USE THE REMOTE CONTROL 9 INSTALLING THE BATTERIES 10 PREPARATION FOR USE 11 CHANNEL CHART 11 PRESETTING THE TUNER MEMORIES 11 MEMORIZING INDIVIDUAL CHANNEL 12 TO ERASE A MEMORIZED CHANNEL 13 SETTING THE SLEEP TIMER 13 OPERATIONS 14 PICTURE ADJUSTMENTS 14 TROUBLESHOOTING GUIDE 16
  • Symphonic ST191B | Owner's Manual - Page 2
    SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THIS SYMBOL INDICATES THAT A THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of
  • Symphonic ST191B | Owner's Manual - Page 3
    SERVICE EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS NEC - NATIONAL ELECTRICAL CODE S2898A POWER SERVICE GROUNDING normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as improper adjustment of other
  • Symphonic ST191B | Owner's Manual - Page 4
    free and easy channel selection, and lets you tune directly to any channel using the 10-key push buttons of the remote control unit. • Remote Control Function-The convenient remote control unit provided with your set offers the 10-key direct channel tuning, Volume UP/DOWN, Channel UP/DOWN, Mute
  • Symphonic ST191B | Owner's Manual - Page 5
    Do not block the ventilation holes at the top and bottom of the television. Do not place the unit on a carpet because this will block water is spilled on your television, unplug the power cord immediately and take the unit to an authorized service center for servicing. • Do not place anything directly on
  • Symphonic ST191B | Owner's Manual - Page 6
    buttons-Press to select the channel. 3 POWER button-To turn Monitor power on and off. 4 INFRARED SENSOR WINDOW-Receives the infrared control signals from the remote control unit. 5 VHF/UHF antenna terminal-Connect a VHF/UHF antenna (75 ohm) or CATV cable (75 ohm). - 6 - EN
  • Symphonic ST191B | Owner's Manual - Page 7
    ANTENNA CONNECTIONS VHF/UHF COMBINED ANTENNA A VHF/UHF combination antenna can be connected to VHF/UHF antenna terminal. VHF/UHF Combination Antenna IBI ANT. N UHF/VHF SEPARATE ANTENNAS Standard VHF antenna and UHF antenna can be connected to VHF/UHF antenna terminal using VHF/UHF combiner. VHF
  • Symphonic ST191B | Owner's Manual - Page 8
    CABLE AND PAY TV From Cable System 75-ohm Coaxial Cable (Not supplied) 0 0ANT. IN f From Cable System (Not supplied) OUTS 0 IN CATV Box 75-ohm Coaxial Cable (Not supplied) J ANT. IN O Note to CATV system installer This reminder is provided to call the CATV system installer's attention to
  • Symphonic ST191B | Owner's Manual - Page 9
    RECALL 3 AUTO ADD/ TV/CATV mFmc, 4 PICTURE SFI FCT NTROI 5 1) OL NI 6 SLEEP LUTE IF VOLUME A ( 7 13 12 11 10 9 8 HOW TO USE THE REMOTE CONTROL 1 POWER button- To turn the unit on and off. 2 NUMBER buttons-Press two digits to directly access channel you choose. Remember to press
  • Symphonic ST191B | Owner's Manual - Page 10
    8 VOLUME buttons- Press to control the volume. INSTALLING THE BATTERIES 1 Slide the battery compartment cover on the remote unit in the direction of the arrow. VOLUME 0001000000000 9 PICTURE CONTROL buttons-Adjust picture sharpness in TV mode. 10 AUTO MEMO button- Press to preset
  • Symphonic ST191B | Owner's Manual - Page 11
    according to the cable service. • The current list in CHANNEL MEMORY may be lost if the TELEVISION is disconnected or power failure to ON. Channel "2" displays in light red. 2 POWER 3 Press TV/CATV button on the remote Control repeatedly. TV/CATV I ) TV 2, STD 1, IRC 1 or HRC 1 are displayed
  • Symphonic ST191B | Owner's Manual - Page 12
    CAN BE DONE WITH THE REMOTE CONTROL OR MANUALLY. Press AUTO MEMO button for more than one second on the remote control unit. The light red area. Proceed to steps 5 and 6 below. 5 Press SKIP/SEARCH button on the remote control until the word "SKIP" is displayed on the screen. I SKIP/ SEARCH SKIP
  • Symphonic ST191B | Owner's Manual - Page 13
    by pressing the CHANNEL UP (or DOWN) button until the desired channel number appears on the screen. Or you may use number buttons of the remote control unit. (Selected channel number displays in light blue. 32 V CHANNEL A SETTING THE SLEEP TIMER The sleep timer function enables you to shut off the
  • Symphonic ST191B | Owner's Manual - Page 14
    at the factory-preset levels. If any adjustments are necessary, adjust the required controls as follows. These steps can be done manually with the Remote Control. Note: For normal use, set to center position. 2 To increase brightness, push PICTURE CONTROL "+" button. To decrease brightness, push
  • Symphonic ST191B | Owner's Manual - Page 15
    COLOR 1 Press PICTURE SELECT button repeatedly until "COLOR" is displayed. TINT 1 Press PICTURE SELECT button repeatedly until "TINT" is displayed. SELECT J COLOR 0D00DEIIH0HINI SELECT ( TINT 00000E1000000 2 If color appears weak and pale, push PICTURE CONTROL"+"button. If the color appears
  • Symphonic ST191B | Owner's Manual - Page 16
    TROUBLESHOOTING GUIDE Sometimes a performance problem can be easily solved by checking seemingly apparent but often overlooked possibilities. Before arranging for service to the television. Picture OK; poor or no sound. • Volume control on remote control • Adjust volume control on remote unit or
  • Symphonic ST191B | Owner's Manual - Page 17
    SPECIFICATIONS GENERAL SPECIFICATIONS Television system Channel coverage VHF UHF CATV Tuning System Channel access Antenna terminals : NTSC-M TV Standard (D) Weight : 39 lbs Accessories : Remote Control unit with 2 "AAA" batteries : Owner's Manual • Designs and specifications are subject to
  • Symphonic ST191B | Owner's Manual - Page 18
    CABLE CHANNEL DESIGNATIONS This model is capable of receiving 181 cable channels. The channels are displayed as 1 thru 125. Cable companies often designate the other channels with letters or letter-number combinations. Please check with your local cable company. The following is a chart of common
  • Symphonic ST191B | Owner's Manual - Page 19
    original retail purchase will be required together with the product to obtain service under this warranty. • • Ito This warranty shall not be extended . THIS WARRANTY DOES NOTCOVER PACKING MATERIALS, ANY ACCESSORIES (EXCEPT REMOTE CONTROL), ANY COSMETIC PARTS, COMPLETE ASSEMBLY PARTS. DEMO OR
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
OWNER'S
MANUAL
19
INCH
COLOR
TELEVISION
ST191
B
Sqmphonic
1
CONTENTS
FEATURES
4
PRECAUTIONS
5
SUPPLIED
ACCESSORIES
5
LOCATION
5
AVOID
THE
HAZARDS
OF
ELECTRICAL
SHOCK
AND
HIRE
5
OPERATING
CONTROLS
AND
FUNCTIONS
6
ANTENNA
CONNECTIONS
7
VHF/UHF
COMBINED
ANTENNA
7
UHF/VHF
SEPARATE
ANTENNAS
7
CABLE
AND
PAY
TV
8
REMOTE
CONTROL
OPERATION
9
HOW
TO
USE
THE
REMOTE
CONTROL
9
INSTALLING
THE
BATTERIES
10
PREPARATION
FOR
USE
11
CHANNEL
CHART
11
PRESETTING
THE
TUNER
MEMORIES
11
MEMORIZING
INDIVIDUAL
CHANNEL
12
TO
ERASE
A
MEMORIZED
CHANNEL
13
SETTING
THE
SLEEP
TIMER
13
OPERATIONS
14
PICTURE
ADJUSTMENTS
14
TROUBLESHOOTING
GUIDE
16
SPECIFICATIONS
17
GENERAL
SPECIFICATIONS
17
ELECTRICAL
SPECIFICATIONS
17
OTHER
SPECIFICATIONS
17
CABLE
CHANNEL
DESIGNATIONS
18
///
Please
read
before
using
this
equipment