Symphonic TVCR19G1 Owner's Manual

Symphonic TVCR19G1 Manual

Get Symphonic TVCR19G1 PDF manuals and user guides View all Symphonic TVCR19G1 manuals
Add to My Manuals
Save this manual to your list of manuals

Symphonic TVCR19G1 manual content summary:

  • Symphonic TVCR19G1 | Owner's Manual - Page 1
    OWNER'S MANUAL Sqmphonic 19-INCH COLOR TVNCR TVCR19G1 C cinD°c. V15 • 'II
  • Symphonic TVCR19G1 | Owner's Manual - Page 2
    meant for uninterrupted service and, that for some specific reason, such as the possibility of the loss of an authorization code for a CATV converter bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to . 10.Power Sources-This TVNCR should be
  • Symphonic TVCR19G1 | Owner's Manual - Page 3
    ELECTRIC SERVICE EQUIPMENT NEC - NATIONAL ELECTRICAL CODE 52898A GROUNDING CONDUCTORS (NEC SECTION 810.21) GROUND CLAMPS POWER SERVICE GROUNDING normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of
  • Symphonic TVCR19G1 | Owner's Manual - Page 4
    cord immediately and take the unit to an authorized Funai service center for servicing. • Do not put your fingers or objects into a tape is played in a TV/VCR which has moisture, it may damage the tape and TV/VCR. Therefore when the condensation approved in the instruction manual. The user could
  • Symphonic TVCR19G1 | Owner's Manual - Page 5
    CONTENTS ■ IMPORTANT SAFEGUARDS 2 ■ TV OPERATION 17 WATCHING A TV PROGRAM 17 ■ PRECAUTIONS 4 GAME MANUAL)... 14 SLEEP TIMER 26 ■ ON SCREEN DISPLAY 16 ■ TROUBLESHOOTING GUIDE 27 ■ SPECIAL FEATURES DEGAUSSING AUTO REWIND-EJECT /6 ■ MAINTENANCE 28 16 ■ SPECIFICATIONS 16 ■ CABLE CHANNEL
  • Symphonic TVCR19G1 | Owner's Manual - Page 6
    shows the elapsed recording or playback time in hours, minutes, and seconds. The "-" indication will appear when the tape is rewound further than the tape counter position "0:00:00". • 181 channel suitable for use with a TV game. • Auto power on system- . SUPPLIED ACCESSORIES Remote Control Unit 2
  • Symphonic TVCR19G1 | Owner's Manual - Page 7
    from : SP mode 1) In the Stop mode, press EJECT button on the remote (Standard Play), LP mode (Long Play) or SLP mode control or press on the (Super Long Play). TVNCR. The cassette will eject. The table below shows the maximum recording/play- 2) Pull the cassette out of the cassette compartment.
  • Symphonic TVCR19G1 | Owner's Manual - Page 8
    1 2 3 4 5 6 78 91011 12 13 14 - REMOTE CONTROL VIEW - POWER EJECT 25 SLEEP 5 6 SEA CD CD 24 15 CD CD CD CHANNEL 12 CD CD CD c CIED A DISPLAY MUTE ( VOLUME I Remote Sensor- Receives the infrared control signals from the handheld remote control unit. 5 POWER button- Press to turn TV/
  • Symphonic TVCR19G1 | Owner's Manual - Page 9
    to display the counter or the P. button- current channel number and current time on the TV • When setting program (for example: setting clock or RESET button- Press to reset counter to 10 R EC button- Press to begin manual recording. 0:00:00. OTR button- Press to activate One Touch Record- 20
  • Symphonic TVCR19G1 | Owner's Manual - Page 10
    BOX Use this connection if your cable system connects directly to your TV/VCR without a converter box. With this connection you, 1) can use your TVNCR Remote Control to select channels, 2) program one or more unscrambled channels for Automatic Timer Recording. From Cable System 75-ohm Coaxial Cable
  • Symphonic TVCR19G1 | Owner's Manual - Page 11
    O O CD EXTERNAL INPUT MODE When using an external input signal (another VCR or camcorder), connect the player's audio/video output ca- bles to the AUDIO IN, VIDEO IN jacks of your AUX TV/VCR. Then press CHANNEL A or V button or enter "00" with number but- ton so that "AUX" appears on the
  • Symphonic TVCR19G1 | Owner's Manual - Page 12
    scanning The tuner stops on the lowest memorized channel. (TV mode: from CH 02/ CATV mode: from CH 01) If you want to recall the selected channels, you can select the desired channel directly with the remote control number button or CH • or V. TO RETURN TO TV MODE WHEN SCANNING Press MENU button in
  • Symphonic TVCR19G1 | Owner's Manual - Page 13
    channel. (TV mode: from CH02 / CATV mode: from CHOI) Make sure ... • Press POWER button to turn on the TVNCR. • You must use the remote control [ON] - SETTING CLOCK - AUTO CLOCK :ON) AUTO CLOG% CH [AUTO) ITV MANUAL CLOCK SET, Press F.FWD/II• or REWRII button repeatedly until [ON] appears. 4
  • Symphonic TVCR19G1 | Owner's Manual - Page 14
    Auto Clock Setting Press MENU button to return to the TV mode. 5 Turn off the TVNCR Press POWER button to turn off the TVNCR for searching the local PBS station. The power must remain off during this search. Ifyou enter the channel number manually, • It may take a few minutes for this search to
  • Symphonic TVCR19G1 | Owner's Manual - Page 15
    MANUAL CLOCK SETTING Make sure ... • You must use the remote control for the following steps. • Power must PROGRAMMING PICTURE Cairn*. IP SEM.* CLCCK CHANNEL SET UP USER'S SET UP LANG C"S'! StP.ETIUC LECI E,; Then, press F.FWD/00- button. 2 Select "MANUAL CLOCK SET" .41,240.4 Press PLAY
  • Symphonic TVCR19G1 | Owner's Manual - Page 16
    ON SCREEN DISPLAY To check the Counter, Clock and Channel number on the TV screen, press DISPLAY button on the remote control. Each time you press DISPLAY button on the remote control, the TV screen will change as follows: Wizen the closed Caption mode is OFF: • In the Counter mode, after 5
  • Symphonic TVCR19G1 | Owner's Manual - Page 17
    with a TV GAME. Make sure ... • You must use the remote control for the following steps. 1 Select "USER'S SET UP" Press MENU button. Press PLAY/A or STOP/V button repeatedly to point to "USER'S SET UP". Then, press F.FWD/I0- button. -MENU- TIMER PROMO/MING PICTURE CONTROL SETTING CLOCK CHANNEL SET
  • Symphonic TVCR19G1 | Owner's Manual - Page 18
    ]) TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK CHANNEL SET UP USER'S SET UP LANGUFM Exit the caption setting mode Press MENU button to return to the TV mode. TO CANCEL THE CLOSED CAPTION SYSTEM Repeat steps [1] and remote control for the following steps. • Power must be turned on. -186L1
  • Symphonic TVCR19G1 | Owner's Manual - Page 19
    NOTE: Tapes recorded in the SP or LP mode will display a noise bar on the TV screen and the picture may revert to Black and White. This is normal. 3) For normal button during playback. Only tapes recorded in the SLP mode will show the least amount of lines. Press PLAY button to return to playback
  • Symphonic TVCR19G1 | Owner's Manual - Page 20
    must use the remote control for the - button. -MENU- TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK CHANNEL SET UP IP USERS SET UP LANGUAGE ENGLISH d .CTal , follow step [2] but select [OFF]. Press MENU button to return to TV mode. 2 Select "ALL" or "BLANK" Press PLAY/A or STOP/V button
  • Symphonic TVCR19G1 | Owner's Manual - Page 21
    SEARCH". Then, press F.FWD/10.- button. -MENU- IiMEA PPOGRANAIING PICTURE COMM". SETTING CLOCK CHANNEL SET UP USERS SET UP LANGUAGE (ENGUSHJ IP CAPTIONA (CAPTION') TIMESE N - 2 Enter your STOP/EJECT button on the TVNCR or the remote control. This will delete the selected time. - 21 - EN 6L24
  • Symphonic TVCR19G1 | Owner's Manual - Page 22
    You can only watch the same TV program that is being recorded. gmaaarensva.armrraxxa.,,,x****34...... , 1 Select the channel to be recorded Press number to the Recording mode. • When in the Pause/Still mode, a display showing 5 "I" marks will appear on the screen. Each "I" mark represents one
  • Symphonic TVCR19G1 | Owner's Manual - Page 23
    the TVNCR or on the remote control. • To show the remaining time, press DISPLAY button repeatedly until "OTR" appears on the TV screen. • Recording stops button to select the desired recording speed (SP, LP or SLP). 4) Press CHANNEL A or V button repeatedly so that "AUX" appears on the screen. 5)
  • Symphonic TVCR19G1 | Owner's Manual - Page 24
    remote control for this procedure. • If a cable box or satellite box is connected with the TV/VCR you will be limited to record only one channel. And the channel selector on the TV/VCR must be selected to the output channel CHANNEL SET UP USERS SET UP LANGUAGE (ENGLISH TON', CTIINETERtrAAr. "MANUAL
  • Symphonic TVCR19G1 | Owner's Manual - Page 25
    must turn off the TVNCR to activate automatic timer recording. If power is not turned off and you continue watching TV, "TIMER REC STANDBY" starts flashing on the TV screen 2 minutes before the programmed start time. TO CORRECT .4 PROGRAM • While setting a program; press REWill button to go back one
  • Symphonic TVCR19G1 | Owner's Manual - Page 26
    remote control. 3) Confirm "TIMER PROGRAMMING" is pointed. 4) Press F.FWD/00- button. The details of programs ap- pear on the TV screen. 5) Press MENU button. The TV screen returns to the TV mode. HINTS: • Make sure the channel , you may not operate the unit manually. • The erase-prevention tab on
  • Symphonic TVCR19G1 | Owner's Manual - Page 27
    TROUBLESHOOTING GUIDE If you have followed the instructions contained in this manual and have difficulty in operating your TV/VCR, locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the problem. SYMPTOM No power. POSSIBLE
  • Symphonic TVCR19G1 | Owner's Manual - Page 28
    TV screen shows a black box You are in the TEXT mode. Select CAPTION mode or CAPTION [OFF]. on certain channels. MAINTENANCE CABINET CLEANING SERVICING TVNCR become inoperative, do not t to correct the problem by yourself. There are no user serviceable parts inside. Turn off, unplug the pow cord,
  • Symphonic TVCR19G1 | Owner's Manual - Page 29
    two-head Tape width: 1/2 inch Tape speed SP: 33.40mm/sec. LP: 16.67mm/sec. SLP : 11.12mm/sec. Tuner channel TV VHF Low : #2-#6 TV VHF High : #7-#13 TV UHF : #14-#69 CATV VHF: 5A MID band : A5-A1, A-I SUPER band : J-W HYPER band : W+1-W+84 Terminals Antenna input : VHF/UHF
  • Symphonic TVCR19G1 | Owner's Manual - Page 30
    of God. THIS WARRANTY DOES NOT COVER PACKING MATERIALS, ANY ACCESSORIES (EXCEPT REMOTE CONTROL). ANY COSMETIC PARTS. COMPLETE ASSEMBLY PARTS. DEMO OR FLOOR MODELS. AND SHIPPING COST,INCURREDINPRESENTING OR SENDING YOURFUNAI/SYMPHONIC PRODUCT FOR SERVICE ARE SHIPPER'S RESPONSIBILITY. CAREFULLY PACK
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
OWNER'S
MANUAL
Sqmphonic
19
-INCH
COLOR
TVNCR
TVCR19G1
C
cinD°c.
•
'II
V15