TASCAM DA-6400 IF-DA64 Owners Manual Addendum
TASCAM DA-6400 Manual
View all TASCAM DA-6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
TASCAM DA-6400 manual content summary:
- TASCAM DA-6400 | IF-DA64 Owners Manual Addendum - Page 1
is changed, it can take several minutes for the system to stabilize. • TASCAM recommends Shielded LAN cables (STP type) to connect the IF-DA64 to the Dante network. ご注意 00IF-DA64 Dante Dante Clock Master iiDante ControllerでDante Preferred MasterとEnable Sync to External iiDA-6400をDante
IF-DA64
D01285300A
ご注意
0
IF-DA64を安定して使用するためには、必ずDante
ネ ッ ト ワ ー ク 以 外 の 外 部 ク ロ ッ ク をDante Clock
Masterに設定してください。
i
Dante ControllerでDante機器のいずれか一台だ
けPreferred MasterとEnable Sync to External
の2つの設定にチェックを入れてください。
i
DA-6400をDante Clock Masterに 設 定 し て 使
用する場合は、DA-6400のClock Masterを「IF-
DA64が装着されたSLOT」に
設定しない
でください。
i
DA-6400をDante Clock Slaveに設定して使用す
る場合は、DA-6400のClock Masterを「IF-DA64
が装着されたSLOT」に設定してください。
0
DA-6400の起動後、Fs変更後、Danteネットワーク
接続変更後は、Danteネットワーク同期が安定するま
で、数分かかる場合があります。
0
IF-DA64を使用する場合は、シールドされたLANケー
ブル(STPケーブル)を使用して、Danteネットワーク
に接続することを推奨します。
Printed in China
NOTICE
•
For stable operation of the IF-DA64, always use an
external clock source as the Dante Clock Master.
•
In the Dante network, be sure to select one
device only to be the network clock master, by
using the “Preferred Master” and “Enable Sync to
External” settings in Dante Controller.
•
When using the DA-6400 as the Dante Clock
Master,
do not set
the DA-6400’s Clock Master
setting to the slot where the IF-DA64 is installed.
•
When the DA-6400 is a Dante clock slave, select
the slot where the IF-DA64 is installed as the
DA-6400’s Clock Master.
•
When the DA-6400 is started, or the FS or Dante
network connection is changed, it can take several
minutes for the system to stabilize.
•
TASCAM recommends Shielded LAN cables (STP
type) to connect the IF-DA64 to the Dante network.