TASCAM DA-6400 IF-AN16/OUT Specifications
TASCAM DA-6400 Manual
 |
View all TASCAM DA-6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
TASCAM DA-6400 manual content summary:
- TASCAM DA-6400 | IF-AN16/OUT Specifications - Page 1
Product Spec Sheet ANALOG OUTPUTS INTERFACE CARD IF-AN16/OUT IF-AN16/OUT Nov, 2016 ■ Specifications Ratings ・Formats and channels 16 channels at 44.1/48/88.2/96kHz, 16-bit/24-bit Analog - TASCAM DA-6400 | IF-AN16/OUT Specifications - Page 2
to 0 dB Other ・Dimensions 107 x 40 x 161.5 mm (width × height × depth, including protrusions) ・Weight 240g ■ Dimensional drawings IF-AN16/OUT ※TASCAM is trademark of TEAC CORPORATION, registered in the U.S. and other countries. ※Other company names, product names and logos are the trademarks or
-
1 -
2
 |
 |
IF-AN16/OUT
0040a
-
1-
TEAC CORPORATION
Nov, 2016
Product Spec Sheet
ANALOG OUTPUTS INTERFACE CARD
IF-AN16/OUT
■
Specifications
Ratings
・
Formats and channels
16 channels at 44.1/48/88.2/96kHz, 16-bit/24-bit
Analog audio output ratings
・
ANALOG 1-8 / 9-16 OUT connectors
Connector:
D-Sub 25-pin
Locking screws:
No. 4-40 UNC (inch type)
Nominal output levels:
+4 dBu, +6 dBu (only when maximum output level is +15 dBu)
Maximum output levels:
+24 dBu, +22 dBu, +20 dBu, +18 dBu, +15 dBu
(Switched according to nominal level of device installed in)
Output impedance:
200 Ω or lower
Output attenuation:
0 to −14 dB (in 0.5dB steps)
•
Applicable load impedance
：
2
kΩ or higher
•
0dBu = 0.775Vrms
Audio performance
・
Frequency response
+0.1 dB/-0.5 dB: 20 Hz/20 kHz (-16 dBFS input, 44.1/48kHz sampling frequency, JEITA)
+0.1 dB/-1.0 dB: 20 Hz/40 kHz (-16 dBFS input, 88.2/96kHz sampling frequency, JEITA)
・
Distortion (THD+N)
0.001% or less
(0 dBFS input, 1kHz, 44.1/48/88.2/96kHz sampling frequency, JEITA)
・
S/N ratio
110 dB or higher
(44.1/48/88.2/96kHz sampling frequency, JEITA)