TASCAM DM-24 Application-Specific Documents DM-24 with Pro Tools
TASCAM DM-24 Manual
View all TASCAM DM-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
TASCAM DM-24 manual content summary:
- TASCAM DM-24 | Application-Specific Documents DM-24 with Pro Tools - Page 1
with Pro Tools My 001 is on a Mac G4 running Mac OS 9.1. I simply have the MIDI in and out of the DM-24 plugged in to the MIDI in and out of the 001. I also have an OMS setup showing just those connections. As a device I have: Manuf: Mackie - TASCAM DM-24 | Application-Specific Documents DM-24 with Pro Tools - Page 2
In Pro Tools Session Startup window MTC to Port is checked and HUI is the chosen port. Under SETUPS-PERIPHERALS-MIDI CONTROLLERS #1 TYPE is HUI Receive from HUI Send to HUI Channels 8 - TASCAM DM-24 | Application-Specific Documents DM-24 with Pro Tools - Page 3
Obviously if you have a larger system with a different OMS setup, your settings will be a little different. But this should give you a good understanding of how the communication works. On the DM-24 EXTERNAL CONTROL page. I have HUI EMULATE ID 01 MIDI RX checked. - TASCAM DM-24 | Application-Specific Documents DM-24 with Pro Tools - Page 4
On the MACHINE CONTROL page I have HUI EMULATE ID 01 TRA checked and REC 1-8. On the OPTION-SYNC/TC page I have SYNC SOURCE and MIDI IN MTC checked. This allows the DM-24 automation to be triggered by the MTC sent from Pro Tools. - TASCAM DM-24 | Application-Specific Documents DM-24 with Pro Tools - Page 5
On the DM-24 EXTERNAL CONTROL page use the cursor to point to the JUMP TO SCREEN icon and press ENTER. This will take you to the HUI control screen. SEND A-E refer to aux sends. If you point to A and press ENTER the encoders on the LCD will show you all of the levels for - TASCAM DM-24 | Application-Specific Documents DM-24 with Pro Tools - Page 6
trigger the DM24's internal automation. This is helpful is you are running audio in to the DM-24. If you are ONLY using the DM-24 as a "control surface" and mixing in Pro Tools, the MTC going to the DM-24 is not needed. The small print HUI is a registered trademark of Mackie Designs Inc. Pro Tools
DM-24 HUI emulation with Pro Tools
My 001 is on a Mac G4 running Mac OS 9.1.
I simply have the MIDI in and out of the DM-24 plugged in to the MIDI in and out
of the 001.
I also have an OMS setup showing just those connections.
As a device I have:
Manuf: Mackie
Model: other
Device ID: 0
Name HUI
Receives MTC is checked
Is Controller is checked
Receives on CH 1