TEAC LR-10 LR-10 Firmware Version 1.02 Release Notes
TEAC LR-10 Manual
 |
View all TEAC LR-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
TEAC LR-10 manual content summary:
- TEAC LR-10 | LR-10 Firmware Version 1.02 Release Notes - Page 1
device. Please visit the TASCAM web site at http://tascam.com to check for the latest firmware. Maintenance items LR-10 Release Notes 4 Use is not a problem with the unit, and battery power is not used. Confirmation of firmware version Confirm the firmware version of your LR-10 before conducting - TEAC LR-10 | LR-10 Firmware Version 1.02 Release Notes - Page 2
tascam.com). 2 Turn the unit's power ON and use the included USB cable to connect it with a computer. This unit will be recognized as an external drive (external storage device) by the computer. 3 Copy the downloaded firmware to the UTILITY folder on the LR-10 firmware version" instructions above to
-
1 -
2
 |
 |
TASCAM LR-10
1
LR-10
Release Notes
Updates
Always use the most recent firmware for this device.
Please visit the TASCAM web site at http://tascam.com to
check for the latest firmware.
Maintenance items
V1.02 Fixes
When a stereo audio file was played back, only the left
•
channel audio of the file would be output from the
built-in speaker. This has been fixed so now a mix of
both left and right channels is output.
V1.01 Fixes
If you pressed and held the
•
Ô
or
button to
search backward or forward at the very beginning or
end of a song, the speed would return to normal. This
issue has been fixed.
If the
•
AREA
item on the
PLAY MODE
screen was
set to
PLAYLIST
, and you set IN (starting) or OUT
(ending) points and then made a move in the playlist
or otherwise edited it, the IN and OUT points would not
be saved correctly. This issue has been fixed.
If the
•
AREA
item on the
PLAY MODE
screen is set to
PLAYLIST
, and you select a file not added on the
PLAYLIST
screen and then use the
LOOP
button to
try to set an IN (starting) or OUT (ending) point, the
following pop-up message will now appear.
File not in PLAYLIST
Note
When operating the unit using USB bus power, if you
output sound from the speaker at near maximum volume,
depending on the computer being used, the power
supply status display might change from the
icon
to the
icon. This is not a problem with the unit, and
battery power is not used.
Confirmation of firmware version
Confirm the firmware version of your LR-10 before
conducting a firmware update.
1
Turn the unit’s power ON.
2
Press the MENU key to open the
MENU
screen.
3
Use the
§
/BROWS or
¶
/MIC button to select
INFORMATION
menu item (highlight the item),
and press the
Á
or
¯
button to open the
INFORMATION
screen.
4
Use the
§
/BROWS or
¶
/MIC button to open the
SYSTEM (3/3)
page and confirm the
System
Ver.
(firmware version) is displayed.
You do not need to update the unit’s firmware if
the version shown is the same as or newer than the
version that you intend to use for the update.
D01141600B