TP-Link AD7200 AD7200 V1 Quick Install Guide

Quick Installation Guide

AD7200 Multi-band Wi-Fi Router

Connecting the Hardware

Turn on the modem, and

then wait about

2 minutes

for it to restart.

Connect the modem to the

Internet port on your router with

an Ethernet cable.

If your Internet connection is through an Ethernet cable from the wall

instead of through a DSL / Cable / Satellite modem, connect the Ethernet

cable directly to the router’s Internet port, then follow steps 5 and 6 to

complete the hardware connection.

Power adapter

7106506096

REV1.0.1

Turn off the modem,

and remove the backup

battery if it has one.

2

Place the router horizontally and extend the

antennas to the maximum angle.

1

Note: For best performance, horizontal installation is recommended.

Antenna direction and position can affect performance in vertical

installation situations.

4

3

Turn on the router.

5

Verify that the following LEDs are on and stable before continuing with

the configuration.

6

On

Internet

5GHz

On

60GHz

On

Power

On

2.4GHz

On

AD7200

Note:

1. If all the LEDs are off, press the LED On/Off button

for 1 second, then check the LEDs again.

2. If the 2.4GHz, 5GHz, and 60GHz LEDs are off, press the Wi-Fi On/Off button

for 2 seconds, then check the

LEDs again in a few seconds.

Power adapter