TP-Link Archer VR200 Archer VR200 V1 Quick Install Guide
TP-Link Archer VR200 Manual
 |
View all TP-Link Archer VR200 manuals
Add to My Manuals
Save this manual to your list of manuals |
TP-Link Archer VR200 manual content summary:
- TP-Link Archer VR200 | Archer VR200 V1 Quick Install Guide - Page 1
Quick Installation Guide AC750 Wireless Dual Band Gigabit VDSL2 Modem Router 7106505441 REV1.0.0 Connecting the Hardware If you don't need the phone service, just directly connect the modem router to the phone jack with a phone cable, then follow steps 3 and 4 to complete the hardware connection. - TP-Link Archer VR200 | Archer VR200 V1 Quick Install Guide - Page 2
phone jack and then reconfigure the modem router by following the instructions in this Quick Installation Guide. A5. Contact your ISP to verify if the DSL line is in good status. A6. If you have tried all the suggestions above and the problem still exists, contact our Technical Support. ©2015 TP-LINK
-
1 -
2
 |
 |
Quick Installation Guide
AC750 Wireless Dual Band Gigabit
VDSL2 Modem Router
7106505441
REV1.0.0
Connecting the Hardware
DSL Splitter
Phone Jack
Connect to the phone (Optional)
Power Adapter
1
Connect the DSL splitter
to the phone jack
.
2
Connect the modem router
to the DSL splitter.
Modem Router
3
Turn on the modem router.
Verify that the hardware connection
is correct by checking these LEDs.
4
Note:
1. The DSL LED
takes about 1 to 2 minutes to stabilize.
2. If the 2.4GHz LED
and 5GHz LED
are off, please press the Wi-Fi
button on the rear panel for 2 seconds, then check the LEDs again in a
few seconds.
Power On
On
5GHz
On
2.4GHz
On
DSL
If you don’t need the phone service, just directly connect the modem router to
the phone jack with a phone cable, then follow steps 3 and 4 to complete the
hardware connection.