TP-Link TL-SM5110-LR TL-SM5110-LRUN V1 Installation Guide
TP-Link TL-SM5110-LR Manual
View all TP-Link TL-SM5110-LR manuals
Add to My Manuals
Save this manual to your list of manuals |
TP-Link TL-SM5110-LR manual content summary:
- TP-Link TL-SM5110-LR | TL-SM5110-LRUN V1 Installation Guide - Page 1
://community.tp-link.com to join TP-Link Community. For technical support and other information, please visit https://www.tp-link.com/support, or simply scan the QR code. If you have any suggestions or needs on the product guides, welcome to email [email protected]. Remove the Transceiver - TP-Link TL-SM5110-LR | TL-SM5110-LRUN V1 Installation Guide - Page 2
TL-SM5110-SR 850 nm TL-SM5110-LR 1310 nm Standards and Protocols IEEE 802.3ae TCP/IP SFF-8472 Cable 50/125 or 62.5/125 μm 9/125 μm Multi-mode Fiber Single-mode Fiber Max. Cable Length 300 m (OM3) 10 km Data Rate Port Type 10 Gbps LC Duplex Power Support you need service, please contact - TP-Link TL-SM5110-LR | TL-SM5110-LRUN V1 Installation Guide - Page 3
statement Product Name: 10GBase SFP+ LC Transceiver Model Number: TL-SM5110-SR/TL-SM5110-LR Responsible party: TP-Link USA Corporation, d/b/a TP-Link North and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
Remove the Transceiver
Install the Transceiver
10GBase SFP+ LC Transceiver
1. Wear an ESD-preventive wrist or ankle strap to prevent ESD damage to
the transceiver.
2. Insert the transceiver into the slot and firmly press it into place.
3. Remove the protective dust plug from the transceiver.
4. Plug fiber-optic cables into the transceiver. Note that the transceiver
works without any additional configuration.
1. Wear an ESD-preventive wrist or ankle strap to prevent ESD damage to
the transceiver.
2. Disconnect the network fiber-optic cables from the transceiver.
4. Reinstall the protective dust plug in the transceiver’s optical bores and
place it on antistatic mat or a static shielding bag.
3. Pull the safety latch downwards to release the transceiver, and then
pull it out from the slot.
Installation Guide
Note:
1. Do not touch the output pins on the transceiver with your hand.
2. Always keep the protective dust plug on the transceiver’s optical bores until you are ready to make a connection.
Caution:
DO NOT point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight.
©2020 TP-Link
7106509054
REV1.1.0
For technical support and other information, please visit
, or simply scan the QR code.
If you have any suggestions or needs on the product guides,
welcome to email
.
To ask questions, find answers, and communicate with TP-Link
users or engineers, please visit
to join TP-Link Community.