TP-Link TL-WA5110G User Guide - Page 100
Destination IP, Advanced options, Direction, transmit, receive, Duration, Data amount, Run Test,
UPC - 845973051327
View all TP-Link TL-WA5110G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Figure 5-29 Speed Test ¾ Destination IP - The Remote device's IP address. ¾ User - Administrator password of the remote device. It should be filled correctly if you want to get a precise estimation. Otherwise, keep it clean. ¾ Advanced options - This is a switch to show advanced test options which are used only for precise estimation. ) Note: If either User or Password is incorrect, we will take a basic test instead. In other words, none of the advance options you set will take effect. ¾ Direction - There are 3 options available for the traffic direction while estimating the throughput. z transmit - Estimate the outgoing throughput (TX). z receive - Estimate the ingoing throughput (RX). z both - Estimate the incoming (RX) first and then the outgoing (TX) afterwards. ¾ Duration - The value you specify here indicate how much time the test should last. ¾ Data amount - The maximal data amount to be sent out during the whole test. ) Note: If both Duration and Data amount are specified, the test will stop after any of them is met. Be sure to click the Run Test button to start a new test after you filled enough information. You can also stop a running test by click Stop Test button at any time. 5.9.6 Reboot Selecting System Tools > Reboot allows you to reboot the device on the screen shown in Figure 5-30. 92