Tecumseh Products OH195EA Operator Manual

Tecumseh Products OH195EA Manual

Get Tecumseh Products OH195EA PDF manuals and user guides View all Tecumseh Products OH195EA manuals
Add to My Manuals
Save this manual to your list of manuals

Tecumseh Products OH195EA manual content summary:

  • Tecumseh Products OH195EA | Operator Manual - Page 1
    's Manual OH195EA/OH195XA (OHH50-65) OH195EP/OH195XP Four-Cycle Engine • Horizontal Crankshaft • Air-Cooled Table of Contents IMPORTANT NOTICE! Safety Definitions ii I. General Safety Precautions 1 II. How to Get Service 3 III. Oil and Fuel Specifications 4 IV. Before Starting Your Engine
  • Tecumseh Products OH195EA | Operator Manual - Page 2
    and (TWC) Three-way Catalyst (if so equipped). TecumsehPower Contact Information For engine adjustments, repairs or warranty service NOT covered in this manual, contact your nearest Authorized TecumsehPower Servicing Dealer. Find them on our website at www.TecumsehPower.com or call TecumsehPower
  • Tecumseh Products OH195EA | Operator Manual - Page 3
    are highly flammable and can explode. Fuel vapors can spread and be ignited by a spark or flame many feet away from engine. To prevent injury or death from fuel fires, follow these instructions: • NEVER store engine with fuel in fuel tank inside a building with potential sources of ignition such as
  • Tecumseh Products OH195EA | Operator Manual - Page 4
    • Keep the disconnected spark plug wire securely away from metal parts where arcing could occur. • Carefully attach the spark plug wire to the grounding post, if provided. • Disconnect battery at negative terminal first, if engine is equipped with a DC electric starter. • Turn all engine switches to
  • Tecumseh Products OH195EA | Operator Manual - Page 5
    repairs and adjustments not covered within this Operator's Manual, and it is intended for individuals who have had adequate training, experience and who practice proper tool usage. Service procedures should be clearly understood and practiced when servicing TecumsehPower engines. • Order as part
  • Tecumseh Products OH195EA | Operator Manual - Page 6
    "FULL" and "ADD" Marks Figure 7. Engine Oil Level 5 4 6 3 7 STOP 2 1 8 10 9 1. Carburetor 2. Primer 3. Muffler 4. Spark Plug Cap 5. Oil Fill Cap 6. Fuel Fill Cap 7. Engine Stop Switch 8. Starter Cord Handle 9. Speed Control 10. Air Cleaner Figure 8. Engine with Oil Fill Dipstick 181-1032-14
  • Tecumseh Products OH195EA | Operator Manual - Page 7
    Oil Fill Plug) If your engine has an oil fill plug go to step 1. If your engine has an oil fill cap, see "I. Oil Fill Cap or Oil Fill Plug with Dipstick" instructions above. 1. Be sure engine is upright and level. 2. Clean area around oil fill plug. See Figure 9. 3. Unscrew oil fill plug. 4. Add oil
  • Tecumseh Products OH195EA | Operator Manual - Page 8
    's instructions) or engine throttle control to "FAST" position. See Figures 11 and 12. Page 6 STOP STOP SLOW RUN FAST CHOKE PRIMER Figure 11. Typical Engine Symbols 4 3 5 6 7 STOP 2 1 8 10 9 1. Carburetor 2. Primer 3. Muffler 4. Spark Plug Cap 5. Oil Fill Cap 6. Fuel Fill Cap 7. Engine Stop
  • Tecumseh Products OH195EA | Operator Manual - Page 9
    (see equipment manufacturer's instructions) or engine throttle control to "FAST" position. NOTE DO NOT operate an electric starter for more than 5 seconds each attempt. 4. Push starter button or turn ignition switch key to start engine. 5. When engine starts: a. Release starter button or ignition
  • Tecumseh Products OH195EA | Operator Manual - Page 10
    B. Engines with Recoil Starters If you have an electric starter, see "A. Engines with Electric Starters" instructions on page 6. Only one of the following two sections will apply to your engine. If you have a manual recoil starter, see Table 4. Table 4. Engines with Recoil Starters If your engine
  • Tecumseh Products OH195EA | Operator Manual - Page 11
    instructions listed in the steps above avoids potential damage to the recoil mechanism. 5. When engine starts: a. Momentarily move choke lever to "1/2 CHOKE" position until engine Servicing Dealer. DO NOT attempt to start or troubleshoot this engine in any other way. STOP Figure 18. Starter Cord
  • Tecumseh Products OH195EA | Operator Manual - Page 12
    reading instructions below. • Keep the disconnected spark plug wire securely away from metal parts where arcing could occur. • Carefully attach the spark plug wire to the grounding post, if provided. • Disconnect battery at negative terminal first, if engine is equipped with a DC electric starter
  • Tecumseh Products OH195EA | Operator Manual - Page 13
    dry. NOTE DO NOT oil foam pre-filter. 4. Replace foam pre-filter onto paper filter. 2 3 1 1. Levers and Linkage 2. Cooling Fins 3. Air Intake Screen Figure 22. Debris Removal Areas 2 3 1 1. .030 in. (0.76 mm) Gap 2. Electrodes 3. Porcelain Figure 23. Resistor Spark Plug 181-1032-14 Page 11
  • Tecumseh Products OH195EA | Operator Manual - Page 14
    cleaner baffle that prevents ice from forming in the carburetor when the engine is run at temperatures below 32°F (0°C). Engines equipped with the baffle will have an opening which draws warm air from the muffler into the air cleaner housing. To work effectively, it is necessary for the baffle to
  • Tecumseh Products OH195EA | Operator Manual - Page 15
    related electrical problems such as: • Inoperative Starter • Discharged Battery • Fuse Replacement • Alternator Maintenance/Repairs See your equipment manufacturer's instructions and an Authorized TecumsehPower Servicing Dealer. G. Carburetor If you think your carburetor needs adjusting, see your
  • Tecumseh Products OH195EA | Operator Manual - Page 16
    Short-Term/Seasonal Storage I. Clean Engine Before servicing the engine remove the carburetor cover and/or blower housing. Remove grass clippings, dirt and debris from the following areas: • Cooling Fins • Air Intake Screen • Levers • Linkage Area • Guards • Carburetor • Head Removing debris will
  • Tecumseh Products OH195EA | Operator Manual - Page 17
    , if provided. 9. Connect spark plug wire to spark plug before attempting to start engine. Figure 25. Disconnecting/Connecting Spark Plug Figure 26. Typical Spark Plug Connection III. Oil Change oil if NOT changed within the last 3 months. See "A. Checking and Changing Oil" instructions on page 10
  • Tecumseh Products OH195EA | Operator Manual - Page 18
    follow maintenance intervals listed in this manual. See Table 5. Table 5. Maintenance Intervals Procedure Time Change Oil Check Oil Level Clean Cooling Fins Change Oil Clean Foam Pre-Filter Replace Paper Filter Check Spark Plug Replace Spark Plug After First 2 Hours When Engine is Warm Every
  • Tecumseh Products OH195EA | Operator Manual - Page 19
    Dealer 181-1032-14 Every 25 Hours or 3 Months 1. Change Oil 2. Clean Foam Pre-Filter Date Owner/Dealer Date Owner/Dealer Date Owner/Dealer Date Owner/Dealer Every 100 Hours or Seasonally 1. Replace Paper Filter 2. Check Spark Plug Date Owner/Dealer Date Owner/Dealer Date Owner/Dealer Date
  • Tecumseh Products OH195EA | Operator Manual - Page 20
    Page 18 181-1032-14
  • Tecumseh Products OH195EA | Operator Manual - Page 21
    NOTES 181-1032-14 Page 19
  • Tecumseh Products OH195EA | Operator Manual - Page 22
    on your small off-road engine for the periods of time listed below, provided there has been no abuse, neglect, unapproved modification, or improper maintenance of your small off-road engine. Your emission control system may include parts such as the carburetor, air cleaner assembly, ignition system
  • Tecumseh Products OH195EA | Operator Manual - Page 23
    -on or modified part. EMISSION-RELATED PARTS INCLUDE THE FOLLOWING: 1. Carburetor Assembly including internal components: a) Carburetor gaskets b) Intake pipe 2. Air Cleaner Assembly including components: a) Air filter element 3. Ignition System including components: a) Spark plug b) Ignition module
  • Tecumseh Products OH195EA | Operator Manual - Page 24
    product, or failure to follow the instructions contained in an Instruction Manual for the operation of the new TecumsehPower engine or part. The cost of normal maintenance or replacement of service on the "Important Engine Information" decal located on the engine housing or an addendum decal
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
Operator’s Manual
OH195EA/OH195XA
(OHH50-65)
OH195EP/OH195XP
Table of Contents
IMPORTANT NOTICE! Safety Definitions
..........................................
ii
I.
General Safety Precautions
.............................................................
1
II.
How to Get Service
..........................................................................
3
III.
Oil and Fuel Specifications
...............................................................
4
IV.
Before Starting Your Engine
.............................................................
4
V.
Starting Your Engine
........................................................................
6
VI.
Stopping Your Engine and Short-Term Storage
...............................
9
VII.
Maintenance
..................................................................................
10
VIII.
Transporting Your Engine
...............................................................
13
IX.
Storing Your Engine
.......................................................................
14
X.
Preventing Forest, Brush and Grass Fires
.....................................
16
XI.
Maintenance Intervals
....................................................................
16
California & US EPA Emission Control Warranty Statement
..........
20
Emission Control System Warranty
...............................................
21
XII.
Warranty Information
......................................................................
22
181-1032-14
(English) 6/01/08
Register Your TecumsehPower Engine
Maintenance Tips
On-Line Store
Locate your nearest TecumsehPower Servicing Dealer
Visit our web site at
www.TecumsehPower.com
LOG ON!
Four-Cycle Engine • Horizontal Crankshaft • Air-Cooled