Toro 20334 Owner's Manual - Page 5
Setup - parts
UPC - 021038203348
View all Toro 20334 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1 nstalling the Handle No Parts Required Procedure Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, Service Dealer. contact an Authorized , Remove the handle _obs from the mower housing (Figure 3). Important: Route the cables to the outside of the handle knobs as you install the handle. [2 Filling the Engine with Oil No Parts Required Procedure Important: Your mower does not come with oil in the engine, but it does come with a bottle of oil. Before starting the engine, fill the engine with oil. Max. fill: 20 oz. (0.59 1), type: SAE 30 detergent oil with an API service classification of SF, SG, SH, SJ, SL, or higher. Note: When the crankcase is empb, pour about 3/4 of the crankcase capacity of oil in the crankcase, then do the following: 1. Move the mower to a level surface. 2. Remove the dipstick by rotating the cap counterclockwise and pulling it out (Figure 4). i G009550 Figure 3 2. Move the handle to the operating position. 3. Install and tighten the handle _obs that you removed in step I . 1. Dipstick Figure 4 , Wipe the dipstick clean with a clean cloth. 4. Insert the dipstick flay into the oil fill tube, then remove the dipstick. 5. Read the oil level on the dipstick. Note: If the oil level is below the Add mark on the dipstick, slowly pour a small amount of oil into the oil fill tube, wait 3 minutes, and repeat steps 3 through 5 until the oil level is at the Full mark on the dipstick (Figure 4).