Toro 38360 Operation Manual - Page 6

Converting from Sweeping to Snowthrowing Important: Disconnect the power from the Power Shovel Plus before performing this procedure. 1. Remove the deflector. 2. Remove the bolt on the side of the housing. 3. Remove the broom from the housing. m-7694 m-7386 1. Tighten the bolt on the side of the housing. 2. Loosen the lower knob on the shaft. 3. Rotate the handle grip to the opposite side of the shaft. 4. Tighten the knob. 5. Ensure that the Power Shovel Plus is in the snowthrower mode as shown. m-7386 m-7385 m-7388 4. Install the rotor in the housing by Inserting the end of the rotor onto the fitted end in the housing and rotating the rotor until it snaps into position. m-7695 Note: You may need to adjust the length of the shaft to comfortably operate in snowthrower mode. Refer to Adjusting the Power Shovel Plus Height on page 3. m-7387 Note: The housing will flex when you install the snowthrower rotor. 6