Toshiba 40E210U User Manual - Page 27

Chapter 5: Setting up your TV Viewing the digital signal meter You can view the digital signal meter in the ANT/ CABLE digital TV input source only. To view the digital signal meter: 1無 Press and open the Setup menu. 2無 Highlight Installation and press . 3無 A new set of Installation menu icons will appear. Open the Terrestrial menu, highlight Signal Meter, and press . 4無 Press pqtu to select the antenna input and digital channel whose signal you want to check. Note: • The physical digital channel number listed in the Signal Meter screen may not correspond to a virtual TV channel number. Contact your local broadcasters to obtain the RF channel numbers for your local digital stations. • The signal strength does not change between virtual channels on the same physical channel. To close the screen and return to the Terrestrial menu: Highlight Done and press . To return to normal viewing: Press . Setting the time zone The Time Zone setup will allow you to specify the correct time zone for your region. This feature will allow the TV status information to show the correct time zone information ( page 49). To set the time zone: 1無 From the Setup menu, highlight Installation and press . A new set of Installation menu icons will appear. 2無 Highlight Time Zone, and press . 3無 Press t or u to select the region, highlight Done, and then press . After the time zone has been set, you will be asked to set the current Daylight Saving Time status. To set the Daylight Saving Time status: 1無 Press t or u to select Yes or No, Highlight Done, and then press . Viewing the system status To view the system status: 1無 Press and open the Setup menu. 2無 Highlight Installation and press . 3無 A new set of Installation menu icons will appear. Open the System Status menu, highlight System Information, and press . 4無 Press tu to scroll through the menu bar to select the Factory Defaults or Support Information and view the related information. To close the screen and return to the Installation menu: Highlight Done and press . To return to normal viewing: Press . Reset Factory Defaults To reset all settings and channels to their factory default values: 1無 Press and open the Setup menu. 2無 Highlight Installation and press . A new set of Installation menu icons will appear. 3無 Open the System Status menu, highlight System Information, and press . 4無 Press tu to scroll through the menu bar to select Factory Defaults. 5無 Highlight Yes and press . 6無 (If PIN code has been set, enter your PIN code. Press t or u to select Done and press .) A warning message will appear, select Yes and press , the TV will turn off automatically after a few seconds. After the TV turns off, unplug the TV power cord and then plug it in again to complete the reset process. To cancel the reset: Select No and press in step 5 above. 27