Toshiba 65HM167 Service Manual - Page 8

Disposing of the Used Lamp Unit - problems

Get Toshiba 65HM167 - 65inch Rear Projection TV PDF manuals and user guides
UPC - 022265000496
View all Toshiba 65HM167 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

7. Reattach the lamp unit door, making sure to insert the hooks on the left side of the door inside the opening in the TV cabinet. 8. Replace the door screw and tighten using a manual screwdriver. NOTE: Make sure the lamp unit door is installed securely; otherwise, the TV may not turn on. 9. Plug in the power cord and turn on the TV. After the initial warm-up period (which may take several seconds for full picture brightness), the TV should operate normally. If any of the following conditions exist, turn off the TV, unplug the power cord, and repeat steps 1-9 to ensure that the lamp unit and lamp unit door are installed correctly: x No picture x Dark picture x TV will not turn on NOTE: If, after repeating steps 1-9, the problem still exists: x In the U.S., call TACP Consumer Solutions at 1-800-631-3811. x In Canada, locate the nearest Toshiba authorized service depot by directing your web browser to www.toshiba.ca; click "Home Entertainment", and then click "Support". Disposing of the Used Lamp Unit CAUTION: Always handle the lamp unit with care. The lamp unit in this TV was designed for safe replacement by consumers; however, if the lamp unit is subjected to intentional or accidental abuse (such as excessive mechanical abuse or handling by children or pets), the unit may break, exposing sharp edges or pinch points. x Place the used lamp unit in the empty box from the new unit. x Keep the lamp unit out of reach of children and pets. x Dispose of the used lamp unit by the approved method for your area. NOTE: The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental considerations. For disposal or recycling information, contact your local authorities or the Electronic Industries Alliance (www.eiae.org). 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
7.
Reattach the lamp unit door, making sure to insert the hooks on the left side of the door inside the opening in the TV cabinet.
8.
Replace the door screw and tighten using a manual screwdriver.
NOTE:
Make sure the lamp unit door is installed
securely;
otherwise,
the TV may not turn on
.
9.
Plug in the power cord and turn on the TV. After the initial warm-up period (which may take several seconds for full picture
brightness), the TV should operate normally. If any of the following conditions exist, turn off the TV, unplug the power cord,
and repeat steps 1-9 to ensure that the lamp unit and lamp unit door are installed correctly:
x
No picture
x
Dark picture
x
TV will not turn on
NOTE:
If, after repeating steps 1-9, the problem still exists:
x
In the U.S., call TACP Consumer Solutions at 1-800-631-3811.
x
In Canada, locate the nearest Toshiba authorized service depot by directing your web browser to www.toshiba.ca;
click "Home Entertainment", and then click "Support".
Disposing of the Used Lamp Unit
CAUTION: Always handle the lamp unit with care.
The lamp unit in this TV was designed for safe replacement by consumers;
however, if the lamp unit is subjected to intentional or accidental abuse (such as excessive mechanical abuse or handling by
children or pets), the unit may break, exposing sharp edges or pinch points.
x
Place the used lamp unit in the empty box from the new unit.
x
Keep the lamp unit out of reach of children and pets.
x
Dispose of the used lamp unit by the approved method for your area.
NOTE:
The lamp unit contains mercury.
Disposal of mercury may be regulated due to environmental considerations. For disposal
or recycling information, contact your local authorities or the Electronic Industries Alliance (www.eiae.org).
7