Toshiba D-VR4XSU Owners Manual - Page 87
Error/Warning message list
View all Toshiba D-VR4XSU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Error/Warning message list General ERROR/WARNING MESSAGE System error. Please wait. System error. Disc might be failed. Press ENTER. Disc error. Incorrect disc. Playback Cannot playback. Region code error. Recording Cannot record. Cannot record. Disc protected. Cannot record. Disc finalized. Data is being written to the disc. No space on the disc. Dubbing Cannot record, exceeds limited number of titles. Cannot record. Protected image. The operation cannot be executed during timer recording standby and recording. Cancel T-REC standby after executing this operation. Unable to shift during duplication process. Duplication aborted. Copying interrupted. CAUSE The power was shut down without completing the termination process due to a power failure or disconnection of the AC cord plug. (Abnormal termination) The data restoration was completed. A scratch or contamination was found on the disc. The disc cannot be identified. A scratch or contamination was found on the disc. A disc specified other than "Region 1" or "Region ALL" was loaded. Recording was tried onto the disc which does not support recording. POSSIBLE SOLUTIONS Wait until the message disappears. Press ENTER, then the screen returns to the normal display. The data may not be restored even if the restoration process is performed. Check the disc and reload it, or use another disc for recording. Check the disc and load a proper disc. Check the disc and reload it, or use another disc for recording. A disc specified other than "Region 1" or "Region ALL" cannot be played back. Load a recordable disc. • Adding data was tried onto the disc re corded in the other unit. • Adding data was tried to the disc where PC data was recorded. Disc erase-protection is applied. Load another disc for recording. Select "Off" to cancel the disc protection from Setup Menu (DISC). Or slide the protect switch to off on the DVD-RAM cartridge itself. Recording was tried onto the finalized Undo finalization or load another disc. disc for recording. The recording termination is processing. Wait until the process is completed. Disc became full during recording. 99 titles were recorded on the disc. Recording was attempted on a copy protected video. An invalid key pressed during timer recording standby and recording. Erase unnecessary titles or load another disc and restart recording. Erase unnecessary titles or load another disc. You cannot record a copy protected video. Wait until the timer recording is complete. Timer recording is standing by. • A copy protected tape is used • Disc protection is set. Cancel the timer recording standby mode. Load another video tape or disc for recording and restart. The video tape or disc became full during Load another video tape or disc for dubbing. recording and restart. NOTE: Any error/warning message other than those above might appear. Take measures against such a message by seeing the possible solutions above. Additional information 2H5-01 P82-87 87 7/25/05, 23:23 87