Toshiba D-VR600 Owner's Manual - English - Page 19

Connections with the TV or audio component Connect to a stereo amplifier with audio output You can enjoy high quality audio by connecting the audio output to your amplifier. Connect the audio output jacks to any line-level inputs (such as AUX, DVD, CD, etc.) of an audio amplifier. Audio (L) output Stereo Amplifier To Audio (L) input To Audio (R) input Introduction Audio cable (not supplied) DVD/VCR Audio (R) output Connect to an AV Amplifier with built-in digital surround If you are using an Amplifier with a built-in digital surround as follows, you can enjoy the various audio systems such as Dolby Digital and DTS by using the optical or coaxial digital output. Use this connection to connect an: • AV amplifier with built-in *Dolby Digital decoder • AV amplifier with built-in *DTS decoder NOTE: You may connect to a TV with a component video cable (not supplied) or S-Video cable (not supplied) instead of a video cable (not supplied). Audio(R) output Audio(L) output Video output Optical digital audio output Audio/Video cable (not supplied) To Audio/Video input TV DVD/VCR Coaxial digital audio output Coaxial digital cable (not supplied) Connect either Optical digital cable (not supplied) AV Amplifier with built-in various decoder as above Connecting the optical digital cable You may connect to an AV Amplifier with an optical digital cable (not supplied) instead of a coaxial digital cable. When you connect the optical digital cable (not supplied), remove the dust protection cap from the rear panel. When not using the optical digital cable, attach the dust protection cap to protect against dust. NOTES: • When you connect the recorder to other equipment, be sure to turn off the power and unplug all the equipment from the wall outlet before any connections. • Turn off the amplifier before you connect or disconnect the recorder's power cord. If you leave the amplifier power on, the speakers may be damaged. • Caution for the optical digital audio output connector: Do not connect to an amplifier (with an optical digital input connector) which does not contain a Dolby Digital or DTS decoder. Otherwise, any attempt to play DVDs may cause such a high level of noise that it may be harmful to your ears and damage your speakers. • DTS audio will output only from the COAXIAL or OPTICAL output. To hear DTS audio, DTS-Decoder is necessary. • When playing DTS-encoded CDs, only noise will be heard from the speakers or analog stereo outputs. • Some DTS decoders which do not support DVD-DTS interface may not work properly with the unit. • The optical or coaxial digital output jack output sounds in the bitstream. 19 2K70101A_E P12-19 19 08`02`07, 20:42