Toshiba DKT3210-SD User Guide - Page 157

ADM/DSS Console DSS Console DSS Console The Direct Station Selection (DSS) console operates alongside an IP or digital telephone to provide 60 additional buttons. The DKT3000/3200-series telephones require a 3000/3200-series DSS. A DDSS3060/3260 example is shown right. Note The IP telephones do not support a DSS console when connected to a Strata CTX running R2.22 or older software. The 60 flexible feature buttons can be assigned as CO line, extension, DSS, One Touch Speed Dial or any other flexible feature. The DDSS3060/3260 console uses dual red and green LEDs to show call and feature status. 209 219 208 218 207 217 206 216 205 215 204 214 203 213 202 212 201 211 200 210 229 239 228 238 227 237 226 236 225 235 224 234 223 233 221 232 221 231 220 230 249 NT 248 AC 247 257 246 256 245 255 244 254 243 253 242 252 241 251 240 250 2039 Note Button numbers in the above figure are examples only. DSS Buttons DSS buttons can appear on both the ADM and DSS Console. Each DSS button is associated with a particular station in your telephone system. DSS buttons can transfer an outside call to the associated station or make a direct call to the associated station. The DSS LED lights steady red when the station associated with the DSS button is ringing, busy on a call, or when the associated station is idle, but all appearances of the station's extensions are busy or in-use by other stations. When the associated DSS button is in the Do Not Disturb mode, the LED blinks red at a slow rate. DSS buttons cannot call station Phantom extension numbers, Distributed Hunt Group Directory Numbers, or ACD Groups. DSS buttons may be configured as One Touch Buttons that may be programmed to call these destinations. The LED colors described in this section apply to the DADM3020/3220 and DDSS3060/3260. Described Flash conditions apply to all DSS console models and the DADM. Strata CIX and CTX IPT/DKT Telephone 08/07 139