Toshiba SD-C2612 User Manual
Toshiba SD-C2612 - DVD-ROM Drive - IDE Manual
 |
View all Toshiba SD-C2612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Toshiba SD-C2612 manual content summary:
- Toshiba SD-C2612 | User Manual - Page 1
TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-C2612 DVD-ROM MOBILE DRIVE USER MANUAL - Toshiba SD-C2612 | User Manual - Page 2
CONTENTS Introduction 1 Setup 3 Using the DVD-ROM 4 Troubleshooting 6 Specifications 7 Drive Connectors 10 - Toshiba SD-C2612 | User Manual - Page 3
- SD-C2612 General Features 100ms Average Access Time (DVD) Lead (Pb) Free Printed Circuit Board Multimedia PC-3 Spec Compliant RPC2 Compliant Drawer Type Manual Load/ Electrical Release 8x sampling & digital filter for CD-Audio DVD-RAM, CD-R and CD-RW Compatible Drive Speed DVD 8X CD-ROM 24X - Toshiba SD-C2612 | User Manual - Page 4
is used to open the disc tray so you can install or remove a disc When you install a disc into the DVD-ROM drive, the BUSY light flashes slowly as it attempts to locate the disc. One of the following will occur: • BUSY light goes out. The DVD-ROM drive is ready to read data from the disc. • BUSY - Toshiba SD-C2612 | User Manual - Page 5
Toshiba's SD-C2612 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download - Toshiba SD-C2612 | User Manual - Page 6
USING THE DVD-ROM Drive - SD-C2612 Drive Operation Inserting Media - Horizontally or Vertically To insert a DVD in a DVD-ROM drive that is mounted horizontally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray - Toshiba SD-C2612 | User Manual - Page 7
prior to their true release dates within those markets. The SD-C2612 DVD-ROM/CD-RW drive supports the current RPC phase 2 industry specifications. This means that when the DVD-ROM drive ships from the factory it is set to the region for which the Operating System was intended. In other words the - Toshiba SD-C2612 | User Manual - Page 8
- SD-C2612 Problem Disc tray cannot be opened Drive is not recognized by system Drive is not recognized by system during Boot process, but is recognized by the Operating System (i.e. XP, Win2000, Win98, Win NT, etc.) BUSY Indicator LED flashes slowly BUSY Indicator LED is constantly ON DVD-ROM can - Toshiba SD-C2612 | User Manual - Page 9
SPECIFICATIONS -SD-C2612 General Interface: ATAPI Compatible DVD-ROM Standard - Read: DVD: CD-ROM: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (ver 1.0 & 2.0, read) DVD-RW (ver 1.1, read) DVD-RAM (ver 1.0 & 2.1, read) CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, MIXED MODE CD, CD-I, CD-I - Toshiba SD-C2612 | User Manual - Page 10
DVD single layer: DVD dual layer: DVD-VIDEO: DVD-R/RW: DVD-RAM (ver 1.0): DVD-RAM (ver 2.1): CD: CD-DA Transfer: CD-RW: Error Rates (with up to 5 retries and layered ECC on) DVD Hard Error Rate: 10-15 max CD Hard Error Rate: mode 1 10-15 max CD Hard Error Rate: mode 2 10-12 max Seek Error - Toshiba SD-C2612 | User Manual - Page 11
Weight 0.5" (12.7mm) 5.04" (128mm) 5.07" (129mm) 7.05oz (200g) Connectors IDE Interface Connector 50 Pin I/F ATAPI Standard Regulatory The SD-C2612 DVD Writeable drive has been certified by the following regulatory agencies: • UL 1950 • CSA C22.2 No. 950 • TUV (EN60950I) • CE standard • DHHS 21 - Toshiba SD-C2612 | User Manual - Page 12
connector is found at the rear of the SD-C2612 DVD-ROM drive. Connector Connecting cable should use Japan Aviation +5V (Motor) 40 41 I +5V (Logic) 42 43 Ground 44 45 Ground 46 47 I CSEL 48 49 I Vendor Unique* 50 *Vender Unique, don't connect pins I/O SIGNAL NAME O Audio R-CH
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-C2612
DVD-ROM MOBILE DRIVE
USER MANUAL