Toshiba SDM1612 User Manual

Toshiba SDM1612 Manual

Get Toshiba SDM1612 PDF manuals and user guides View all Toshiba SDM1612 manuals
Add to My Manuals
Save this manual to your list of manuals

Toshiba SDM1612 manual content summary:

  • Toshiba SDM1612 | User Manual - Page 1
    TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-M1612 DVD-ROM DRIVE USER MANUAL
  • Toshiba SDM1612 | User Manual - Page 2
    CONTENTS Introduction 1 Setup 3 Using the DVD-ROM Drive 6 Troubleshooting 9 Specifications 10 Drive Connectors 13
  • Toshiba SDM1612 | User Manual - Page 3
    INTRODUCTION - SD-M1612 DVD-ROM Drive General Features Tray Loading Mechanism 3-way Disc Eject (eject button, software, emergency eject hole) Average Random Access Time CD-ROM DVD DVD-RAM 85ms 95ms 170ms DAE (Digital Audio Extraction) Audio Capability MPC3 Compatibility Multi-Read Capability
  • Toshiba SDM1612 | User Manual - Page 4
    -CD, CD Extra, CD-RW, CD-R) CD-R (Read) CD-RW (Read) Front Panel Loading Tray Figure 1.SD-M1612 DVD-ROM Drive Front Panel Load disc using tray. Busy Indicator When you install a disc into the DVD-ROM drive, the BUSY light flashes slowly as it attempts to locate the disc. One of the following
  • Toshiba SDM1612 | User Manual - Page 5
    SETUP - SD-M1612 DVD-ROM The following steps must be performed to properly install your drive: • Set Drive Jumper Settings • Connect Audio Cable (optional) • Attach IDE BUS Cable • Attach Power Cable • Mount Drive Jumper Settings The mode select jumpers are 6 straight angle pins located on the rear
  • Toshiba SDM1612 | User Manual - Page 6
    faceplate if required. Refer to your computer systems manual for removal information. If the DVD-ROM drive is replacing a CD-ROM or DVD-ROM, remove drive presently installed in your system. Your Toshiba DVD-ROM drive can be placed in any free half-height drive slot at the front of your computer. (It
  • Toshiba SDM1612 | User Manual - Page 7
    all the necessary cables, push the DVD-ROM drive completely into the computers drive slot. Mount drive per your computers instructions. The screw length should not exceed 30.5mm (measured from outside surface of side or bottom of drive to tip of screw). Replace computer cover and all outer screws
  • Toshiba SDM1612 | User Manual - Page 8
    USING THE DVD DVD-ROM Drive - SD-M1612 Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is mounted horizontally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's Loading tray by pressing the Eject Button. 2. Place disc into drive's Loading
  • Toshiba SDM1612 | User Manual - Page 9
    Loading Tray. Usage Guidelines • Keep the disc tray closed when not using the DVD-ROM Drive. • Do not press down on the disc tray when opening or closing it. the high-speed technology and do not indicate a problem with the drive. Emergency Ejection CAUTION: The following procedure is intended only
  • Toshiba SDM1612 | User Manual - Page 10
    depth. Inserting more than 50mm may damage the DVD-ROM drive. Handling Media DVD media is sensitive to dust and fingerprints. Carefully handle media by its edges only. If a DVD movie skips or hangs during playback, clean the media. Most DVD video playback issues are mediarelated and can be remedied
  • Toshiba SDM1612 | User Manual - Page 11
    - SD-M1612 Problem Disc tray cannot be opened Drive is not recognized by system Drive is not recognized by system during Boot process, but is recognized by the Operating System (i.e. XP, Win2000, Win98, Win NT, etc.) BUSY Indicator LED flashes slowly BUSY Indicator LED is constantly ON DVD-ROM can
  • Toshiba SDM1612 | User Manual - Page 12
    SPECIFICATIONS -SD-M1612 General Interface ATAPI Compatible DVD-ROM Standards DVD DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R, DVD-RW, DVD-RAM CD CD-DA CD-ROM CD-I Bridge (Photo-CD, Video CD) Multi-session (Photo-CD, CD Extra, CD-RW, CD-R) CD-MINI CD-TEXT CD+(E)G CD-ROM-XA CD-I CD
  • Toshiba SDM1612 | User Manual - Page 13
    Performance Rotational Speed DVD-ROM (6.0X - 16X) single layer (4.1X - 10X) dual layer DVD-R (Ver 2.0), DVD-RW (2 - 4.8X) DVD-R (Ver 1.0) (2 - 4.8X) DVD-RAM (Ver 1.0) (2X) DVD-RAM (Ver 2.1) (1X) DVD-Video CSS-disc (2 - 4.8X) CD-ROM, CD-R/RW(20.7 - 48X) CD-DA Transfer (14 - 32X) CD-DA/Video CD (4X -
  • Toshiba SDM1612 | User Manual - Page 14
    Reliability MTBF Power ON Hours ON/OFF Cycles Number of Access Operating Duty Cycle MTTR Audio Number of Channels Frequency Response Distortion Output Levels Headphone Analog Line Out Digital Line Out Environmental Ambient Temperature Operating Storage Shipping Temperature Gradient Operating Storage
  • Toshiba SDM1612 | User Manual - Page 15
    Laser Type Wave Length Semiconductor Laser and 3-beam System 770 - 795 nm Semiconductor Laser and 1-beam System 770 - 650 nm Regulatory The SD-M1612 DVD-ROM drive has been certified by the following regulatory agencies: • UL 1950 • CSA C22.2 No. 950 • TUV (EN60950I) • CE standard • CB • DHHS 21
  • Toshiba SDM1612 | User Manual - Page 16
    DRIVE CONNECTORS -SD-M1612 Figure 1.SD-M1612 DVD-ROM Drive Rear Panel - Connectors Power Power is supplied to your DVD-ROM drive by the connection with your computer's +5V/+12V Connector power cable to the power socket at the back of drive. One side of the plug has chamfered edges, so the power
  • Toshiba SDM1612 | User Manual - Page 17
    Interrupt Request Host 16 BIT I/O Host Address Bus BIT 1 Passed Diagnostics Host Address Bus BIT 0 Host Address Bus BIT 2 Host CHIP Select 0 Host CHIP Select 1 Drive Active/Drive 1 Present 15
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-M1612
DVD-ROM DRIVE
USER MANUAL