Toshiba TDP-T95 User Manual - Page 27

CONTROL terminal - data projector

Get Toshiba TDP-T95 PDF manuals and user guides View all Toshiba TDP-T95 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Specifications (Continued) ■ CONTROL terminal ● Pin assignment 7 8 6 5 3 4 21 Mini DIN 8 pin connector ● Interface format 1 Communication method 2 Communication format 3 Data format Pin No. 1 2 3 4 5 6 7 8 Signal Name RXD CTS DSR GND RTS N.C TXD GND Description Receiving data Consent to send Data set ready Signal ground Request to send No connection Sending data Signal ground RS-232C, 9600bps, No Parity, Data Length: 8 bits; Stop Bit Length: 1 bit STX (02h) Command (3Byte) ETX (03h) Only 1 command valid per communication. For input commands, only ASCII-compliant all-uppercase alphanumeric characters supported. 4 Replies Acknowledge ACK (06h) CR (0Dh) Data ... Normally ended ACK (06h) ESC (1Bh) ... Aborted No acknowledge NAK (15h) If commands are to be sent consecutively, wait for the response from the projector before sending the next command. ● Main Commands Item Power on Power off Icon display on Icon display off Auto setting (RGB input) Status display on Status display off Command PON POF MO0 MO1 PAT DON DOF Note • Contact your dealer for control cable and other commands. 52

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
52
Specifications (Continued)
■
CONTROL terminal
●
Pin assignment
7
6
8
5
4
3
2
1
Signal Name
RXD
CTS
DSR
GND
RTS
N.C
TXD
GND
Pin No.
1
2
3
4
5
6
7
8
Description
Receiving data
Consent to send
Data set ready
Signal ground
Request to send
No connection
Sending data
Signal ground
Mini DIN 8 pin connector
●
Interface format
1
Communication method
RS-232C, 9600bps, No Parity, Data Length: 8 bits;
Stop Bit Length:
1 bit
2
Communication format
STX (02h)
Command (3Byte)
ETX (03h)
Only 1 command valid per communication.
3
Data format
For input commands, only ASCII-compliant all-uppercase
alphanumeric characters supported.
4
Replies
Acknowledge
ACK (06h)
CR (0Dh)
Data
...
Normally ended
ACK (06h)
ESC (1Bh)
...
Aborted
No acknowledge
NAK (15h)
If commands are to be sent consecutively, wait for the response from the projector
before sending the next command.
●
Main Commands
Item
Command
Power on
PON
Power off
POF
Icon display on
MO0
Icon display off
MO1
Auto setting (RGB input)
PAT
Status display on
DON
Status display off
DOF
Note
•
Contact your dealer for control cable and other commands.