URC Vivido-Switches Owners Manual
URC Vivido-Switches Manual
 |
View all URC Vivido-Switches manuals
Add to My Manuals
Save this manual to your list of manuals |
URC Vivido-Switches manual content summary:
- URC Vivido-Switches | Owners Manual - Page 1
screws. After completing successful installation LED on device will blink until programmed. For detailed programming instructions for your switch, refer to your controller manual. Neutral White Black Red Hot Load (Ground) Green Neutral FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT - URC Vivido-Switches | Owners Manual - Page 2
Cut Dimensions: 2.75"W x 6.125"H 2 sided print, Fold in fourths, with logo at top of page facing outward. Final Size: 2.75"W x 1.5"H
-
1 -
2
 |
 |
RF Single Pole Switch with Ground
–
VL-9501-MNS-X
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1:
This device may not cause harmful interference, and
2:
This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
FCC CAUTION:
Any changes or modifications not
expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
RF-SW-U-EN (REV. A)
Installation Instructions
Important:
Turn circuit breaker OFF or remove fuse(s)
and test that power is off.
Must be installed and used in
accordance with electrical codes.
Caution:
Use only copper wire with this device. Do not
use with aluminum wire.
Delayed off — when lights are
on, pressing switch for 2 seconds initiates a delayed
turn off.
Programmable for 1 to 240 seconds.
To install:
Connect wires per wiring diagram as follows:
• Remove pre-stripped insulation on device wires.
• Strip wires in box 1/2”.
• Twist ends of stripped wires together as per
schematic.
• Twist on wire connectors clockwise until secure.
• Connect green ground wire to bare wire, and mount to
box with screws.
After completing successful installation LED on device
will blink until programmed.
For detailed programming
instructions for your switch, refer to your controller
manual.
Multi-location
Switch
Accessory
Switch
Single Pole
Load
Neutral
Hot
Neutral
(Ground) Green
White
Black
Red
Universal Remote Control, Inc.
500 Mamaroneck Ave.
Harrison, NY 10528
(914) 835-4484
www.UniversalRemote.com