Uniden ACS1SGL Owner s Manual

Uniden ACS1SGL Manual

Get Uniden ACS1SGL PDF manuals and user guides View all Uniden ACS1SGL manuals
Add to My Manuals
Save this manual to your list of manuals

Uniden ACS1SGL manual content summary:

  • Uniden ACS1SGL | Owner s Manual - Page 1
    AppCam Solo Quick Start Guide
  • Uniden ACS1SGL | Owner s Manual - Page 2
    What's in the Box AppCam Solo Camera x1 Reset Needle x1 Magnetic Mount x1 Screw Mount x1 CR123A CR 123A Batteries Screws (in pack) x4 x1 Opener x1 2 General Introduction Micro SD Card Slot Reset Button Daylight Sensor Lens Status LED Built-in Mic Built-in PIR Motion Sensor Speaker
  • Uniden ACS1SGL | Owner s Manual - Page 3
    remove the batteries from camera to avoid corrosion. Uniden AppCam Solo Supports • 3V CR123A non-rechargeable batteries • 3.6V~4.2V CR123A rechargeable new set of 4 batteries (the standard batteries we provide) will support up to 180 days in standby mode, or 800 minutes (IR LEDs off in daytime
  • Uniden ACS1SGL | Owner s Manual - Page 4
    . Set up the Camera Please follow the prompt tone to configure the camera Please run App. Click the "Add New Device" button, and follow the instructions to set up the camera. 1. Please click the " '' button in the top right corner to add the camera. 6 2. Scan QR code on the camera. 3. Click
  • Uniden ACS1SGL | Owner s Manual - Page 5
    4. Click the button "I have heard the voice prompt" to enter the next page. If you did not hear the voice prompt, please press "I did not hear the voice prompt" for help. 5. Enter the Wi-Fi password of the selected Wi-Fi network and press "I have entered the correct information" to enter the next
  • Uniden ACS1SGL | Owner s Manual - Page 6
    Wi-Fi connection failed! Please check the Wi-Fi settings and try again. 7. If you hear the above voice prompt, please press "I heard 'Wi-Fi connection failed' " for help. Wi-Fi connection succeeds! 8. If you hear the above voice prompt, please press "I heard 'Wi-Fi connection succeeds' " to finish
  • Uniden ACS1SGL | Owner s Manual - Page 7
    Device Menu 10. Please tap the camera and follow the steps to sync the time, and then start live view or go to "Device Settings" for more configurations. Menu Add New Device Enable/Disable PIR Motion Sensor (in default, the PIR sensor is enabled). Device Settings Access the Live View Battery Status
  • Uniden ACS1SGL | Owner s Manual - Page 8
    ! Important Notes for Reducing False Alarms For reducing false alarms, please note: • Do not install the camera facing any objects with bright lights, including sunshine, bright lamplights, etc. • Do not install the camera in a place within 15 meters where there are frequently moving vehicles. •
  • Uniden ACS1SGL | Owner s Manual - Page 9
    How to Install How to Install (using screw moun(uts)ing screw mount) Wall Mount Wall Mount 1 Front 2 Back Tree Mount Tree Mount How to Remove Step 1: Step 1: Step 2: Step 2: Step 1: Step 1: Screw the security mounStcprelawtethe seLcautcrihtytmheousnetcpulraittey mounLtaotnchittshe security
  • Uniden ACS1SGL | Owner s Manual - Page 10
    the owner's manual for this product. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are the defective unit & return it to you without charge for parts, service, or any other cost (except shipping & handling) incurred by warrantor
  • Uniden ACS1SGL | Owner s Manual - Page 11
    uniden.com
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
AppCam Solo
Quick Start Guide