Uniden BEARCAT 680 English Owner's Manual
Uniden BEARCAT 680 Manual
The manual viewer requires the flash plugin to be installed and enabled.
To view this page ensure that Adobe Flash Player version 10 or greater is installed.
Uniden BEARCAT 680 manual table of contents:
-
Page 1
® 680 Owner's Manual Printed in China U01UT389ZZA(0) -
Page 2
... INSTALLATION ...7 Using Your Bearcat 680...7 S/RF Meter ...7 To Receive...8 To Transmit ...8 Preventive Maintenance ...9 Maintenance ...9 Troubleshooting ...10 Servicing ...10 SpEcifications...11 Two-Year Extended Warranty ...12 Radio Code Definitions ...14 Uniden is a registered trademark of Uniden ... -
Page 3
... 680 and check the contents against this list: ƒƒ Bearcat 680 CB 2-way mobile radio ƒƒ Microphone ƒƒ Mounting Bracket Kit ƒƒ DC Power Cord ƒƒ 6-pin to 4-pin... your place of purchase immediately. Description Your Uniden Bearcat 680 represents the highest quality communications device ... -
Page 4
... a motorist. This is an FCC rule and applies to all CB operators. 6. 7. 8. 9. Microphone socket (6 poles) 9/19: Emergency ... RF Gain. Improves reception in strong signal areas. PA/CB: Selects PA (Public Address) or CB (Citizens Band). Do not use PA function unless an external speaker is connected... -
Page 5
13 14 15 16 17 13. Antenna: Connects antenna to the unit. 14. PA SP: Connects optional external 8-ohm, 4-watt speaker for use as a public address system. To prevent acoustic feedback, separate the microphone from the speaker when operating the PA at high output levels. 15. EXT. SP: ... -
Page 6
... bracket before beginning installation. 1. Select a location that is convenient for operating the radio, but does not interfere with the driver or passenger. 2.... antenna is very important. To achieve the maximum transmission distance, Uniden strongly recommends that you install only a high quality ... -
Page 7
... Install 6-Pin to 4-Pin Adapter The Bearcat 680 is pre-configured for Uniden's new 6-pin wireless,..., available in 2012. Your Bearcat 680 comes with an adapter to connect the radio's 6-pin microphone .... 1. Insert the 6-pin side of the adapter into the Bearcat 880 6-pin microphone connection. 2. Plug ... -
Page 8
...noise, weak signals, and strong signals. ƒƒ Turn SQUELCH back clockwise until the hiss stops. Only clearer signals get through. Set Squelch only when the radio is not receiving a strong signal. 5. Press LO/DX button to set the RF gain sensitivity to Local or Distance. 6. Press HI/LO to adjust... -
Page 9
.... Be sure all screws and mounting hardware are tight. Maintenance The Bearcat 680 is designed to give you years of trouble-free service. There are no user-... the same type fuse. Use only the fuse specified for your Bearcat 680. Failure to do so may void your warranty. ... -
Page 10
Troubleshooting In the event of system malfunction, perform the following procedures: Problem Unit does not ...after performing the above checks, call the Uniden Customer Service Center at 1-800-297-1023.../telephone technician for servicing and aligning this CB radio product. When ordering parts, be sure... -
Page 11
SpEcifications GENERAL Channel: Frequency Range: Frequency Control: Antenna Impedance: Power Input: Current Drain TX: RX: Operating Temperature: Accessories: AM Full Modulation 1.5A (max) At no signal: 200mA -22°F to 140°F (-30°C to 60°C) DC Power Cord Microphone Microphone Hanger Mounting ... -
Page 12
... installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this ...(F) installed or programmed by anyone other than as detailed by the owner's manual for this product. STATEMENT OF REMEDY: In the event that the product does not ... -
Page 13
... FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the ... freight prepaid, by traceable means, to warrantor at: Uniden America Corporation Parts and Service Division 4700 Amon Carter Blvd Fort Worth, TX... -
Page 14
... following list contains common "10-Codes" used by CB radio operators for faster communication and better ... Relay message Busy, stand by Out of service, leaving air In service, subject to call Repeat message ... 10-94 10-99 10-200 Meaning Trouble at this station Confidential information Correct time is ... -
Page 15
-
Page 16