Uniden GMR325-2 English Owners Manual

GMR325-2

GMR325-2

*Range may vary depending on environmental and/or topographical conditions.

•

15 GMRS / 7 FRS Channels

•

Long Battery Life

•

Extended Long Range*

•

Channel Scan

•

Channel Monitor

•

Battery Strength Meter

•

Call Button

•

Roger Beep

•

Keytone on/off

1

Antenna

2

PTT (Push-To-Talk) Button

3

Channel/scan up Key

4

Channel/scan down Key

5

Call Key

6

Speaker

7

Power On/Off Key

8

Volume up/mon (monitor) Key

9

Volume down/mon (monitor) Key

10

Microphone

11

Channel Indicator

12

Receive Indicator

13

Battery Level Indicator

14

Transmit Indicator

Congratulations on your purchase of the Uniden

GMR325-2 radio. This product is a lightweight, palm-

sized radio. Use it at sporting events to stay in contact

with family and friends, hiking, skiing, outdoors, or in a

neighborhood watch for vital communication.

PACKAGE CONTENTS

Your package contains the 2 GMR325 radios, this

reference guide and 2 belt clips.You will need to

purchase 6 AAA alkaline batteries in order to

operate these units.

FCC GMRS LICENSE

The GMR325-2 radio operates on the General

Mobile Radio Service (GMRS) frequencies which

require a Federal Communications Commission

license to operate. For licensing information

and application forms, visit the FCC on-line

at:www.fcc.gov/wtb/uls or call the FCC hotline

at 1-800-418-3676. If you have any questions you

can contact the FCC direct at 1-888-225-5322.

INSTALL THE OPTIONAL BATTERIES

Your GMR325-2 radio uses 3 AAA alkaline

batteries (not included) for power. We recommend

using high quality alkaline batteries.

To install the batteries:

1) Make sure your radio is OFF.

2) Remove the battery compartment door by

pressing on and sliding the compartment door,

allowing the door to be removed.

3) Install 3 AAA Alkaline batteries (not included)

into the battery compartment. Be certain to

follow the + and

–

symbols in the compartment.

Installing the batteries incorrectly will prevent the

unit from operating.

4) Replace the battery compartment door by sliding

the door into place.

USING THE RADIO

In order to get the most out of your new radio, read

this reference guide completely before attempting to

operate the radio.

Turning the Radio On and Adjusting the Volume

1) Press and hold the

key to turn the radio ON.

2) To change the volume level press the

volume/monitor

▲

or

▼

key to increase or

decrease the volume level.


key to turn the radio OFF.

Adjusting the Sound (Key Beeps)

Your radio emits a beep each time one of the keys

(except for the

PTT

button and

call

key) is pressed.

The sound of the Key Beep will increase or

decrease depending on the volume level setting.

To turn OFF this beep:

Press and hold the

call

key while turning ON the radio.

To turn ON this beep:

Turn the radio OFF and ON again.

Choosing a Channel

Your GMR325-2 radio has 22 channels you can

use to talk to others. In order to speak to someone,

each of you must be set to the same channel.

To choose a channel:

Press the

channel/scan

▲

or

▼

key to increase

or decrease the channel number displayed.

Channel Scan Feature

Your GMR325-2 radio has a channel Scan feature

that allows you to easily Scan all 22 channels. When

an active channel is detected, the unit will pause on

that channel until the channel is clear. Then after a 2

second delay, the unit will continue scanning.

Pressing

PTT

button while the Scan is paused on a

channel will allow you to transmit on that channel.

To turn ON channel scanning:

Press and hold either the

channel/scan

▲

or

▼

key.The channel number on the display

will rapidly cycle through the channels.

To turn OFF channel scanning:

Press either the

channel/scan

▲

or

▼

key.

Talking on Your Radio

To talk to others using the radio:


PTT

button and speak in a

clear, normal voice about 2-3 inches away from

the microphone.

While you are transmitting the

tx

icon is

displayed.To avoid cutting off the first part of

your transmission, pause slightly after pressing

the

PTT

button before you start talking.

2) When you are finished speaking, release the

PTT

button.You can now receive incoming calls.

While receiving, the

rx

icon is displayed.

Transmitting a Call Alert Tone

Your GMR325-2 radio is equipped with a call tone

that will be transmitted when the

call

key is pressed.

To transmit the call alert tone, press the

call

key.

The tone will automatically be transmitted for a fixed

length of time.

Auto Squelch Feature

The GMR325-2 is equipped with an automatic

squelch system which shuts off weak transmissions

and unwanted noise due to terrain conditions or if

you have reached your range limit.

SPECIFICATIONS

Channels

15 GMRS / 7 FRS

Operating Frequency

UHF 462.5500-

467.7125 MHz

Power Source

3 AAA Alkaline Batteries

(not included)

Output Power

500mW Conducted

Battery Life

25 Hours typical

(5/5/90 duty cycle)

Frequency Chart

Ch.

Freq.

Ch.

Freq.

1

462.5625

12

467.6625

2

462.5875

13

467.6875

3

462.6125

14

467.7125

4

462.6375

15

462.5500

5

462.6625

16

462.5750

6

462.6875

17

462.6000

7

462.7125

18

462.6250

8

467.5625

19

462.6500

9

467.5875

20

462.6750

10

467.6125

21

462.7000

11

467.6375

22

462.7250

Monitor Mode Feature

Your GMR325-2 radio allows you to listen for weak

signals on the current channel at the press of a key.

To turn ON monitor mode:

Press and hold the

volume/monitor

▲

or

▼

key.

The

rx

icon will blink.

To turn OFF monitor mode:

Press the

volume/monitor

▲

or

▼

key. The

rx

icon

will stop blinking.

Automatic Power Save Feature

Your GMR325-2 has a unique circuit designed to dramat-

ically extend the life of the batteries. If there is neither

transmission nor an incoming call within 2 seconds, your

radio switches to the Power Save mode.The radio is still

able to receive transmissions in this mode.

KEYLOCK ON/OFF

Press and hold the

call

key until the "L" appears. After

1 second, the LCD will return to the channel display.

To exit Keylock on mode, press and hold

call

again.

Note:

While in keylock on mode, it will still receive

transmissions.

ROGER BEEP

Roger Beep is a BEEP that is sent to notify the end

of transmission.

Roger Beep can be heard through the speaker when

Key Beep is on.

Roger Beep is transmitted even if key beep is turned

off. However Roger Beep will not be heard from the

speaker.

To turn OFF Roger Beep: Press and hold the

channel/scan

▲

Key while turning on the radio.

Note:

If you press either the

channel/scan

▲

or

▼

key while the unit is pausing on a

channel, scanning will resume.

Uniden GMR325-2 English Owners Manual

Uniden GMR325-2 Manual

Uniden GMR325-2 manual content summary: