ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio
ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio Manual
 |
View all ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio manuals
Add to My Manuals
Save this manual to your list of manuals |
ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio manual content summary:
- ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio - Page 1
PA500S/PA503S/PA503X/PA503W/ PA503SP/PA503XP/PG603X/ PG603W/PG703X/PG703W Lamp Swapping Instruction - ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio - Page 2
Replacing the lamp Turn the power off and disconnect the projector from the power outlet. yy To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before changing the lamp. yy To reduce the risk of severe burns, allow the projector to cool for at least - ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio - Page 3
7. Use the handle to slowly pull the lamp out of the projector. CAUTION yy Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector. yy Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials. yy Do not - ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio - Page 4
11. Tighten the screws that secure the lamp cover. CAUTION yy Loosen screw may cause a bad connection, which could result in malfunction. yy Do not over tighten the screw. 11-1 11-2 Replacing the lamp After powering on the projector, open the OSD menu. Go to ADVANCED > Lamp Settings > Reset Lamp - ViewSonic PG703X - 1024 x 768 Resolution 4 000 ANSI Lumens 1.96-2.15 Throw Ratio - Page 5
-
1 -
2 -
3 -
4 -
5
 |
 |
PA500S/PA503S/PA503X/PA503W/
PA503SP/PA503XP/PG603X/
PG603W/PG703X/PG703W
Lamp Swapping Instruction