Viking DMOD241SS Installation Instructions
Viking DMOD241SS Manual
 |
View all Viking DMOD241SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking DMOD241SS manual content summary:
- Viking DMOD241SS | Installation Instructions - Page 1
, broken or loose drawer guides and dents inside the cavity or on the front side of the drawer. If there is any damage, do not operate the appliance and contact your dealer or a VIKING AUTHORIZED SERVICER. Important notes to the installer • Read all of the Installation Manual before installing the - Viking DMOD241SS | Installation Instructions - Page 2
Given dimensions provide be constructed of plywood strong enough to support the weight of the oven (about microwave interior will easily accommodate a 9" x 13" oblong dish or a bag of microwave Allow (RQE" overlap Floor must support 100 lbs. 19" to top of floor 24" cabinet min. FIGURE 1 FIGUREs - Viking DMOD241SS | Installation Instructions - Page 3
instructions, consult a qualified electrician or service person. Electrical Outlet Location FIGURE 4 6" (153 mm) Anti-tip Block 5" (127 mm) 4" (101.6 mm) Drawer Carefully guide the appliance into the prepared opening. Avoid pinching the cord between the oven and the wall. 3. Slide the drawer all - Viking DMOD241SS | Installation Instructions - Page 4
the drawer front. Before you call for service Read the BEFORE YOU CALL and operating instruction sections in your Use and Care Manual. Manual for Viking's toll-free service number and address. Please call or write if you have inquiries about your microwave product and/or need to order parts. VIKING - Viking DMOD241SS | Installation Instructions - Page 5
algún daño, no opere el electrodoméstico y comuníquese con su distribuidor o PERSONAL DE SERVICIO AUTORIZADO DE VIKING. NOTAS IMPORTANTES PARA EL INSTALADOR • Lea por completo el Manual de instalación antes de instalar el Horno DrawerMicro. • Retire todos los materiales de embalaje antes de conectar - Viking DMOD241SS | Installation Instructions - Page 6
bloque antivolcaduras Deje un traslapo de (RQE" La superficie o piso debe soportar 100 libras 19" hasta la superficie del piso FIGURA 1 Gabinete de 24"min. Las figuras 1 y 2 contienen varias medidas de hornos microonda tipo gaveta extraíbles para que usted tenga una referencia al planificar la - Viking DMOD241SS | Installation Instructions - Page 7
BLOQUE ANTIVOLCADURAS PROCEDIMIENTO NORMAL DE INSTALACIÓN INSTRUCCIONES DE INSTALACIÓN DEL BLOQUE ANTIVOLCADURAS Para reducir el riesgo de volcadura de la gaveta, el bloque antivolcaduras debe ser instalado correctamente a una distancia de 14 13/16" porUbeincacciimónaddele la superficie en la cual - Viking DMOD241SS | Installation Instructions - Page 8
Manual de uso y cuidado para ver las instrucciones de limpieza. UBICACIÓN DEL MODELO Y NÚMERO DE SERIE La placa de identificación, que incluye el modelo y el número de serie ía en su Manual de uso y cuidado para obtener el número de teléfono gratuito y dirección de servicio de Viking. Por favor ll - Viking DMOD241SS | Installation Instructions - Page 9
dimensions et espaces indiqués aux pages 2, Consultez les FIGURE 1. DÉBALLAGE DU Four DrawerMicro™ Retirez tout le matériau d'emballage du DrawerMicro Oven. N'ENLEVEZ PAS LE COUVERCLE DU GUIDE DE SERVICE AGRÉÉ VIKING. ces instructions avec le consommateur. Instructions de faits pour supporter la - Viking DMOD241SS | Installation Instructions - Page 10
13 po ou un sac de maïs soufflé pour micro-ondes. Dimensions du Four DrawerMicro Emplacement de prise électrique 5 po (6po) Bloc supporter 100lbs 19 po jusqu'à la surface du sol Prévoir chevauchement de (RQE po Placard de 24 po min. FIGURE 1 Les FIGUREs 1 et 2 contiennent plusieurs dimensions - Viking DMOD241SS | Installation Instructions - Page 11
BLOC ANTI-BASCULEMENT ÉTAPES D'INSTALLATION HABITUELLES INSTRUCTIONS POUR L'INSTALLATION DU BLOC ANTIBASCULEMENT Pour réduire le risque de basculement du tiroir, il faut installer le bloc antibasculement conformément aux soit complètement - Viking DMOD241SS | Installation Instructions - Page 12
de mise à la terre ENTRETIEN, NETTOYAGE ET SERVICE Consultez le manuel d'utilisateur pour des instructions sur le nettoyage. EMPLACEMENT DES NUMÉROS DE MOD utilisateur pour trouver le numéro de service sans frais et les coordonnées per tinentes de Viking. Veuillez nous téléphoner ou nous écrire
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
IMPORTANT - PLEASE READ AND FOLLOW
• INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
• THE INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE CONSUMER WHO SHOULD RETAIN FOR LOCAL
INSPECTOR’S USE AND FOR FUTURE REFERENCE.
• FOR
SAFETY CONSIDERATIONS
DO NOT INSTALL DRAWER IN ANY COMBUSTIBLE CABINETRY, WHICH IS NOT IN
ACCORD WITH THE STATED CLEARANCES AND DIMENSIONS ON PAGE 2, SEE FIGURE 1.
UNPACKING YOUR
DrawerMicro
Oven
Remove all packing materials from inside the DrawerMicro
Oven. DO NOT REMOVE THE WAVEGUIDE COVER,
which is located on the top of the appliance.
Remove the feature sticker, if there is one. Check the
drawer for any damage, such as misaligned or bent drawer,
damaged drawer seals and sealing surfaces, broken or
loose drawer guides and dents inside the cavity or on
the front side of the drawer. If there is any damage, do
not operate the appliance and contact your dealer or a
VIKING AUTHORIZED SERVICER.
IMPORTANT NOTES TO THE
INSTALLER
•
Read all of the Installation Manual before installing the
DrawerMicro Oven.
•
Remove all packing material before connecting the
electrical supply.
•
Observe all governing codes and ordinances.
•
Be sure to leave these instructions with the consumer.
IMPORTANT NOTES TO THE
CONSUMER
Keep this manual with your Use and Care Manual for future
reference.
•
As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use and Care Manual. Read all
and follow carefully.
•
Be sure your DrawerMicro Oven is installed and
grounded properly by a qualified installer or service
technician.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING:
If the information in this manual is not
followed exactly, a fire or electrical shock may result that
could cause property damage, personal injury or death.
WARNING:
To reduce the risk of tipping, the DrawerMicro
Oven must be secured by a properly installed Anti-Tip
block.
•
This appliance must be electrically grounded in
accordance with local codes.
•
Make sure the wall coverings and the cabinets around
the DrawerMicro Oven can withstand the heat
generated by the appliance.
WARNING:
Never leave children alone or unattended
in the area where a appliance is in use. Never leave the
drawer open when the microwave is unattended.
WARNING:
Stepping, leaning or sitting on the drawer
may result in serious injuries and can also cause damage
to the appliance.
•
Do not use the DrawerMicro Oven as a storage
space.
This creates a potentially hazardous situation.
•
Check that the time-of-day is in the display. If not, touch
Stop/Clear
to prevent unintended use.
Sealing Surface
Waveguide Cover
Oven Cavity
DrawerMicro
™
Oven
INSTALLATION INSTRUCTIONS