Viking DMOS201SS Installation Instructions
Viking DMOS201SS Manual
 |
View all Viking DMOS201SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking DMOS201SS manual content summary:
- Viking DMOS201SS | Installation Instructions - Page 1
Viking Installation Guide Designer Microwave Built-In Trim Kit - Viking DMOS201SS | Installation Instructions - Page 2
and ordinances. UÊ The installer should leave these instructions with the consumer who should retain for local inspector's use and for future reference. WARNING This built-in trim kit is designed for use ONLY with Viking microwave ovens specifying builtin trim kit DMTK302 on the rating label on the - Viking DMOS201SS | Installation Instructions - Page 3
Microwave Oven DMOS201 24" (60.9 cm) 13-3/8" (33.9 cm) 19-1/8" (48.7 cm) Width Height Depth Overall 17-3/8" 10-1/2" 18-5/8" 2.0 cu. ft. 120VAC/60 Hz 1.5 KW 13 amps 46 lbs. (20.9 kg) (44.1 cm) (26.6 cm) (47.3 cm) Built-In Trim Kit Department of Health and Human Services (DHHS) rule, CFR, - Viking DMOS201SS | Installation Instructions - Page 4
BUILT-IN TRIM KIT FLUSH MOUNTING TEMPLATE FOR DESIGNER SERIES MICROWAVE OVEN 4-3/16" (106.4 mm) 3-15/16" (100 mm) NOTES: UÊ If the Depth (C) dimension is greater to support the weight of the oven and floor load (approximately 100 pounds). The floor should be level for proper operation of the oven. - Viking DMOS201SS | Installation Instructions - Page 5
Flush Mount Configuration Microwave Oven and Frame Assembly glaFssLaUre SfluHsh wMithOthUe cNabTineCt ONFIGURATION- Microwave Oven and Frame Assembly and one (1) bottom spacer are required. Spacers are not included in the kit and must be fabricated by installer. See figures 3 and for spacer - Viking DMOS201SS | Installation Instructions - Page 6
Installation Illustration 6 - for Flush Mount Bottom Duct Assembly CENTER THE BOTTOM DUCT Mounting Bracket Assembly Position the mounting brackets to align with the predrilled holes that were drilled with the mounting template. FLUSH MOUNT BRACKET figure figure MAKE BOTTOM SCREW A FLANGE - Viking DMOS201SS | Installation Instructions - Page 7
outlet. BALL STUD BACK OF FRAME ASSEMBLY SMALL STAINLESS DECORATIONS ON TOP figure CABINET INSTALL Carefully guide the assembled oven into the prepared opening. Slide the oven onto the Bottom Duct Assembly. See figure . FRAME INSTALL SNAP ATTACHMENT LOCATIONS ON MOUNTING BRACKETS Position - Viking DMOS201SS | Installation Instructions - Page 8
CM) FOR 30" W LOWER OVEN Performance Checklist 1. Make sure the unit has been installed according to all of the Installation Instructions and the required Mounting Template. 2. Plug in the power cord. 3. Keep the Use & Care Manual and Installation Manual. Viking Range Corporation 111 Front Street
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Viking Installation Guide
Designer Microwave Built-In Trim Kit