Viking FDWB301R Installation Instructions

Viking FDWB301R Manual

Get Viking FDWB301R PDF manuals and user guides View all Viking FDWB301R manuals
Add to My Manuals
Save this manual to your list of manuals

Viking FDWB301R manual content summary:

  • Viking FDWB301R | Installation Instructions - Page 1
    Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com F20904A EN UL C UL (101212) Professional/Custom Panel Built-In Full Height
  • Viking FDWB301R | Installation Instructions - Page 2
    leave these instructions with the serviced • Assure that floor will support unit, door panels and contents (approximately 1200 lbs/540 kg) • Provide a properly grounded electrical outlet • Assure that location will permit appliance messages in this manual and on your appliance. Always read and
  • Viking FDWB301R | Installation Instructions - Page 3
    until appliance is completely installed and secured per installation instructions. Use two or more people to move and install appliance. Failure any significant sources of water or moisture. • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets which are not installed
  • Viking FDWB301R | Installation Instructions - Page 4
    Overall height from bottom Overall depth from rear Cutout width Cutout height Cutout depth Electrical requirements Maximum amp usage Overall capacity Approximate shipping weight FDWB301 30" (76.2 cm) 82-3/4" (210.2 cm) min. to 84-1/16" (213.5 cm) max. To front edge of side trim: 23-13/16" (60.5 cm
  • Viking FDWB301R | Installation Instructions - Page 5
    Cutout Dimensions (Professional/Custom) 3-1/2" (8.9 cm) 2" x 4" Mounting Board [1-1/2" (3.8 cm) x 3-1/2" (8.9 cm)] Attached to anti-tip mounting bracket Note: If unit is installed deeper than 24" (61.0 cm), then shim behind anti-tip bracket thickness by the same amount 1-1/2" (3.8 cm) 8-1/4" (20
  • Viking FDWB301R | Installation Instructions - Page 6
    Cabinet Information (Professional) Professional models fit "semi-flush" in standard 24" (61.0 cm) deep cabinet openings. The door face protrudes 2-1/16" (5.2 cm) from the cabinet face. The handle protrudes an additional 2-1/2" (6.4 cm) into the room. Cabinet Information (Professional) TOP VIEW 1-
  • Viking FDWB301R | Installation Instructions - Page 7
    Cabinet Information (Professional with Flush Mount Trim) Professional models with Flush Mount Trim fit "flush" in standard 24" (61.0 cm) deep cabinet openings with no protrusion into the room except 2-1/2" (6.3 cm) handle depth. Cabinet Information (Professional with Flush Mount Trim) Professional
  • Viking FDWB301R | Installation Instructions - Page 8
    Cabinet Information (Professional with Flush Mount Trim) Cabinet Information (Custom Panel) Custom Panel models, [3/4" (1.9 cm) thick panels and custom handles locally supplied], fit flush in 25" (63.5 cm) deep (countertop depth) cabinet openings with no protrusion into room except custom handles.
  • Viking FDWB301R | Installation Instructions - Page 9
    Cabinet Information (Custom Panel) Custom Panel models, [3/4" (1.9 cm) thick panels and custom handles locally supplied], fit flush in 25" (63.5 cm) deep (countertop depth) cabinet openings with no protrusion into room except custom handles. Cabinet Information (Custom Panel) Custom Panel models
  • Viking FDWB301R | Installation Instructions - Page 10
    Custom Side Panel Dimensions (Professional - Standard Mount) TOP VIEW 3/16" (0.5 cm) thick back filler panel 3/4" (1.9 cm) thick end panel (2572.-03/c8m") 6(1"5.2 cm) 5/32" (0.4 cm) (2572.-03/c8m") (2(211380.854.52-c-1tc7mo/m/18m6m""aixn..))* 2(526-.34/1cm6") 6(1"5.2 cm) (2(211380.854.52
  • Viking FDWB301R | Installation Instructions - Page 11
    (Custom Panel Model) Panels must not weigh more than 50 pounds per door. Pre-drill the holes in the panel per the panel dimension instructions. (See Panel Dimensions for proper hole locations.) Place the panel onto the door and using 1/2" (1.3 cm) #8 wood screws, attach the panel in 12 places
  • Viking FDWB301R | Installation Instructions - Page 12
    Custom Wood Facing Dimensions Each wine rack has a wood facing which can be removed. The facings can be stained, painted, or removed and replaced with alternative wood facings. Note: A scrap sample should be tested in the unit before attaching permanent changes to your wine cellar fronts. Some
  • Viking FDWB301R | Installation Instructions - Page 13
    instructions could result in fire or electrical shock. IMPORTANT: If the power cord is damaged, it must be replaced by a Viking qualified technician or a Viking Range contact the floor to support and stabilize the full required to remove shipping brackets. Slip appliance dolly between unit and skid.
  • Viking FDWB301R | Installation Instructions - Page 14
    Home Security System Connection NOTE: Contact a qualified electrician or authorized agent from alarm company to connect your home security system to the wine cellar. Home security system connection must be hooked up before the unit is installed. 1. Remove the four mounting screws attaching the unit
  • Viking FDWB301R | Installation Instructions - Page 15
    Cellar Before moving the wine cellar in place, confirm the finished dimensions, electrical location, minimum door and shelf clearances, and door panel instructions. 1. Position wine cellar in front of cutout. 2. Verify operation by plugging power cord in receptacle. Power switch will be shipped in
  • Viking FDWB301R | Installation Instructions - Page 16
    Door Stop/Hinge Adjustment DOOR STOP 1. Using a 3/16" Allen wrench, remove door stop pin located in bottom hinge. 2. The pin is factory set 110°. For 120° swing, move the pin to the utmost forward stop hole. For 90° swing, move the pin to the utmost rear stop hole. HINGE ADJUSTMENT 1. Using a 3/16"
  • Viking FDWB301R | Installation Instructions - Page 17
    having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range Corporation at (888) 845-4641 or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W Greenwood, Mississippi 38930 USA The serial number and
  • Viking FDWB301R | Installation Instructions - Page 18
    34 35
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
U
L
C
U
L
Viking Installation Guide
Professional/Custom Panel
Built-In Full Height Wine Cellar
F20904A EN
(101212)