Viking VGR7362 Installation Instructions

Viking VGR7362 Manual

Get Viking VGR7362 PDF manuals and user guides View all Viking VGR7362 manuals
Add to My Manuals
Save this manual to your list of manuals

Viking VGR7362 manual content summary:

  • Viking VGR7362 | Installation Instructions - Page 1
    Installation Professional Freestanding Ranges / Built-in Rangetops VGR7362, VGR7482, VDR7362, CVDR7362, VDR7482, CVDR7482 VRT736, VRT748,
  • Viking VGR7362 | Installation Instructions - Page 2
    Table of Contents Warnings & Important Safety Instructions 3 Dimensions / Specifications - Rangetops 6 Dimensions - Ranges 7 Specifications - Ranges 8 Clearance Dimensions (Proximity to Cabinets 24 Door Replacement 25 Final Preparation 25 Performance Checklist 26 Service & Registration 27 2
  • Viking VGR7362 | Installation Instructions - Page 3
    Gas Code ANSI Z223.1 INFPA54. • The installer must leave these instructions with the consumer who should retain for local inspector's use and for is very important. We have provided many important safety messages in this manual and on your appliance. ALWAYS read and obey all safety messages. This
  • Viking VGR7362 | Installation Instructions - Page 4
    or moisture. • Viking Range, LLC will NOT warranty any problems resulting from GFI IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, instructions. -If you cannot reach your gas supplier, call the fire department. • Installation and service must be performed by a qualified installer, service
  • Viking VGR7362 | Installation Instructions - Page 5
    DANGER GAS LEAK HAZARD To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO NOT USE AN OPEN FLAME TO CHECK FOR GAS
  • Viking VGR7362 | Installation Instructions - Page 6
    max. 25-1/4" (64.1 cm) Shipped natural or LP/Propane gas; field convertible with conversion kit (purchased separately); minimum required service line 1/2" (1.3 cm) ID. Gas manifold pressure Electrical requirements Natural 5.0" W.C.P. / Liquid propane L/P 10.0" W.C.P. 120 VAC/60 Hz 4ft. (121.9 cm
  • Viking VGR7362 | Installation Instructions - Page 7
    Dimensions - 36"/48" Ranges ((134925711--.1.776//cc88mm"")) ((9935315..743--1c9ct5mmo//1))16mm6"ai"nx.. 8" (20.3 cm) 30" (76.2 cm) 27-3/4 (70.5 cm) 2-1/4" (5.7 cm) 35-15/16" (91.3 cm) min. to 37-9/16" (95.4 cm) max. 19-3/8" (49.2 cm) 25-1/4" (64.1 cm) 26-15/16" (68.4 cm) 46-5/16" (117.6 cm)
  • Viking VGR7362 | Installation Instructions - Page 8
    or LP/Propane, accepts standard residential 1/2" (1.3 cm) ID gas service line. Unit is field convertible with proper conversion kit Shipped Natural or Below cooking surface (36" [91.4 cm] and below) • Sides - 0" • Top grate support - 36" (91.4 cm) Above cooking surface (above 36" [91.4 cm]) • Sides
  • Viking VGR7362 | Installation Instructions - Page 9
    , accepts standard residential 1/2" (1.3 cm) ID gas service line. Unit is field convertible with proper conversion kit combustible construction: Below cooking surface (36" [91.4 cm] and below) • Sides - 0" • Top grate support - 36" (91.4 cm) Above cooking surface (above 36" [91.4 cm]) • Sides - 12"
  • Viking VGR7362 | Installation Instructions - Page 10
    Clearance Dimensions (Proximity to Cabinets) • This range may be installed directly adjacent to existing 36" (91.4 cm) high base cabinets. IMPORTANT: The side panel MUST be 3/8" (.95 cm) above the adjacent base cabinet countertop. This can be accomplished by raising the unit using the adjustment
  • Viking VGR7362 | Installation Instructions - Page 11
    of the hood being 66" (167.6 cm) to 72" (182.9 cm) above the floor. Refer to the range hood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood. WoodO/Cveormlapyosite ((7116268672""t..mmo69 accinmmx..)) WoodO/Cveormlapyosite
  • Viking VGR7362 | Installation Instructions - Page 12
    attached to unit. See "Electrical Connection" section for grounding instructions. Must be fused seperately from any other circuit. Electrical Requirements the intended gas supply. Manual shut-off valve: This installer-supplied valve must be installed in the gas service line before the appliance in
  • Viking VGR7362 | Installation Instructions - Page 13
    Electrical & Gas Requirements Flexible Connections: If the unit is to be installed with flexible couplings and/or quick-disconnect fittings, the installer must use a heavy-duty AGA design-certified flexible connector of at least 1/2" (1.3 cm) ID (with suitable strain reliefs) in compliance with
  • Viking VGR7362 | Installation Instructions - Page 14
    burner base on top of the burner flange and the burner head on top of the burner base. Place burner grate on top of grate support. 14
  • Viking VGR7362 | Installation Instructions - Page 15
    Installation - Ranges NOTICE DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle. Removing the door must be done by your dealer, a qualified licensed plumber, or certified gas
  • Viking VGR7362 | Installation Instructions - Page 16
    Installation - Ranges Leg Installation 1 2 Legs are packed in cardboard top pack. Note: Legs should be installed near to where appliance is to be used, as they are not secure for long transit. 3 1 2 1 3 Note: It is strongly recommended that a pallet or lift jack be used rather than tilting.
  • Viking VGR7362 | Installation Instructions - Page 17
    - Dual Fuel Ranges Electrical Connection (3-wire) - Dual Fuel Ranges Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. WARNING Electrical shock hazard. To avoid risk or electrical shock, personal injury or death; grounding product to the frame of the
  • Viking VGR7362 | Installation Instructions - Page 18
    Installation - Dual Fuel Ranges Electrical Connection (3-wire) Dual Fuel Ranges (cont.) 4 5 1 Attach line #1 (red) and line #2 (black) leads to outside terminals. Attach neutral wire (white) to center terminal on the terminal block. 6 Push supply cord toward terminal block to relieve strain,
  • Viking VGR7362 | Installation Instructions - Page 19
    Installation - Dual Fuel Ranges Electrical Connection (4-wire) Dual Fuel Ranges 1 2 Remove access door. 3 Remove supply cord strain relief bracket and three supply cord mounting screws on the terminal block. 4 Remove grounding screw. Cut-off and discard ground strap. 5 Feed supply cord up
  • Viking VGR7362 | Installation Instructions - Page 20
    Installation - Dual Fuel Ranges Electrical Connection (4-wire) (cont.) 7 1 8 Push supply cord toward terminal block to relieve strain, reattach supply cord strain relief bracket over supply cord. Reattach access door. Leveling/Adjustments/Alignment 1 2 Measure the four corners in cutout
  • Viking VGR7362 | Installation Instructions - Page 21
    Installation - Ranges Leveling/Adjustments/Alignment (con't) 3 4 Move unit into opening. 5 (03.9/58"cm) Check that unit is level side to side and front to back. Side trim of the lowest corner must be 3/8" (0.95 cm) above countertop. 6 If leveling is required, move unit out of opening. 7 1 1
  • Viking VGR7362 | Installation Instructions - Page 22
    HAZARD To reduce the risk of property damage or personal injury; install anti-tipping device provided in accordance with the installation instructions in this document. Device must be engaged properly to prevent product from tipping over. 2 M+e1a/s4u"re(m.6e4nctm(A) ) Range Width "X" Dimension
  • Viking VGR7362 | Installation Instructions - Page 23
    personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO performed by your dealer, a qualified licensed plumber, or gas service company. 23
  • Viking VGR7362 | Installation Instructions - Page 24
    . Place burner bases on top of the burner flanges and burner heads on top of the burner base. Place burner grate on top of grate support. (See "Proper alignment of Burner Head".) (03.9/58"cm) Check that unit is level side to side and front to back. The side trim must
  • Viking VGR7362 | Installation Instructions - Page 25
    Installation - Ranges Door Replacement 1 Reattach door to range. 3 2 1 1 2 Open door completely. Fold latches forward until locked in place. Close door. Proper alignment of Burner Head When placing the burner head on the burner base, carefully align the locator key in the outer edge below the
  • Viking VGR7362 | Installation Instructions - Page 26
    Final Preparation • All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If buildup occurs, DO NOT use steel wool, abrasive cloths, cleansers, or powders! If it is necessary to scrape stainless steel Performance Checklist A
  • Viking VGR7362 | Installation Instructions - Page 27
    on the back side of the range. Record the following information indicated below. You will need it if service is ever required. Model number Serial number Date of purchase Date installed Dealer's name Address These installation instructions should remain with the unit for future reference. 27
  • Viking VGR7362 | Installation Instructions - Page 28
    Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit vikingrange.com 066425-000A EN (093018)
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Installation
Professional Freestanding Ranges /
Built-in Rangetops
VGR7362,
VGR7482,
VDR7362, CVDR7362, VDR7482, CVDR7482
VRT736,
VRT748,