Viking VMOS 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation
Viking VMOS Manual
View all Viking VMOS manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking VMOS manual content summary:
- Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 1
Installation Guide Microwave Built-In Trim Kit - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 2
plates from the product. This may void the warranty. • Please observe all local and national codes and ordinances. • The installer should leave these instructions with the consumer who should retain for local inspector's use and for future reference. • This built-in trim kit is designed for use ONLY - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 3
.9 cm) N/A N/A N/A 120VAC/60 Hz (UL) 117VAC/60 Hz (CSA) 1.55 KW 1.5 KW 13 amps (UL) 13 (CSA) 60 lbs. (27.2 kg) CONVENTIONAL VMOS201SS/VMOS501SS 24" (60.9 cm) 13-3/8" (33.9 cm) 19-1/4" Width Height Depth Overall (48.9 cm) 17-3/8" 10-1/2" 18-5/8" 2.0 cu. ft. N/A (44.1 cm) (26.6 cm) (47 - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 4
), the outlet location may be in any area on the rear wall. The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 lbs.) and should be level for proper operation of the oven. Note: While the proper functioning of the - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 5
with the two (¾") SCREWS (C). 7 CABINET INSTALLATION: Place the oven adjacent to the wall or cabinet opening. Plug the power cord into the electrical outlet. Carefully guide the assembled oven into the prepared opening. Slide the oven on the Bottom Duct Assembly. See figure 7. 4 E - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 6
Steel Scoops • (10) Stainless Machine Screws • (1) Flush Mount Template • (2) Side Trim * See FLUSH MOUNT TEMPLATE for additional installation instructions. " SCREW (B) SCREW (B) SCREW (B) SCREW (B) FRAME INSTALLATION: Position the BACK FRAME to align with the predrilled holes that were drilled - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 7
between the microwave and the lower oven: 2" (5.08 cm) for 27"W and 30"W. See Figure #. The trim kits described in this installation guide, and listed below, are NOT TO BE INSTALLED ABOVE GAS OVENS. VMTK272SS VMTK277SS VMTK307SS VMTK302SS VMTK362SS VMTK367SS For more product information, call - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 8
Guide d'installation Kit de garniture à encastrer pour four à micro-ondes F - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 9
IMPORTANT-Prière de Lire et de Suivre ! • Prière de lire attentivement toutes ces directives avant de commencer. • Veiller à DÉBRANCHER LA FICHE du four à micro-ondes de la prise électrique avant d'installer la garniture à encastrer. Retirer la table tournante de la cavité du four. • Le kit comprend - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 10
13 (CSA) S/O Poids approx. à l'expédition. 60 lbs. (27,2 kg) 19 lbs. (8,6 kg) 20 lbs. (9,1 kg) 23 lbs. 10,5 kg Descriptión TRADITIONNEL VMOS201SS/VMOS501SS VMTK272 VMTK302 VMTK362 Largeur hors tout 24 po (60,9 cm) 26-1/2 po (67,3 cm) 29-1/2 po (74,9 cm) 35-1/4 po (89,5 cm) Hauteur - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 11
l'emplacement de la prise peut être situé n'importe où sur le mur arrière. Le plancher de l'ouverture doit être en contreplaqué assez fort pour supporter le poids du four et sa propre charge (environ 45,5 Kg [100 lb]). Il doit être à un niveau convenable pour l'utilisation du four. Remarque : Bien - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 12
d'évacuation 5A Installation en surface 6 schéma schéma VIS C ENSEMBLE DU CONDUIT D'ÉVACUATION ASSEMBLAGE DU CONDUIT D'ÉVACUATION : Retirer les coussins du support adhésif. Appliquer les coussins aux brides de l'ensemble conduit comme indiqué par les flèches. Voir schéma 5A. 5B ÉCART "A" sch - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 13
Installation en surface 7 9 VIS (B) VIS (B) schéma schéma POSE DANS L'ARMOIRE : Placer le four près de l'ouverture du mur ou de l'armoire. Brancher le cordon d'alimentation dans la prise électrique. Guider avec précaution le four assemblé dans l'ouverture préparée. Faire glisser le four sur l' - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 14
latérales * Voir GABARIT DE MONTAGE ENCASTRÉ pour obtenir des instructions d'installation complémentaires. " INSTALLATION DE LA DÉCORATION : Placer de large. Voir schéma ". Les kits à encastrer décrits dans ce guide d'installation, et indiqués ci-dessous, NE DOIVENT PAS ÊTRE INSTALLÉS AU - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 15
Instrucciones de Instalación Juego de Molduras para Empotrado para Horno Microondas S - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 16
IMPORTANTE - Lea y siga las instrucciones • Antes de comenzar, lea estas instrucciones completa y detalladamente. • Asegúrese de DESCONECTAR el horno microondas del tomacorriente eléctrico antes de instalar el juego de moldura para empotrado. Retire el plato giratorio de la cavidad del horno. • El - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 17
. máx. en amperios 1,55 KW 1,5 KW 13 amps (UL) 13 (CSA) Peso aproximado de embarque 60 lbs. (27,2 kg) Descripción CONVENCIONAL VMOS201SS/VMOS501SS Ancho total 24" (60,9 cm) Altura total desde la parte inferior 13-3/8" (33,9 cm) Profundidad total desde la parte 19-1/4" posterior (48 - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 18
Abertura del gabinete o pared Ensamblaje del ducto de escape Haga una abertura en la pared o en el gabinete como se indica en la figura 1. La profundidad debe tener un mínimo de 20-1/8" (51.1 cm). Si la dimensión de la profundidad (C) es mayor a 21" (53.3 cm), la ubicación de la toma de corriente - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 19
Ensamblaje del ducto de escape Instalación en superficie 5A 6 figura figura ENSAMBLAJE DEL DUCTO DE ESCAPE: Retire los amortiguadores del adhesivo. Los amortiguadores se deben aplicar a las bridas del ensamblaje del ducto como indican las flechas. Vea la figura 5A. 5B TORNILLO C CONJUNTO DE - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 20
Instalación en superficie Instalación del montaje al ras figura 8 BASE CONJUNTO DEL DUCTO INFERIOR CAVIDAD DEL DUCTO INSTALACIÓN EN GABINETE: Evite que el cable quede entre el horno y la pared. Ajuste la posición del horno de modo que las patas del horno encajen en los agujeros del CONJUNTO DEL - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 21
Instalación del montaje al ras (A) Altura (B) Peso (C) Profundidad (D) (E) CONVECCIÓN 27" 30" 36" 21-5/16" (542 cm) 21-5/16" (542 cm) 21-5/16" (542 cm) 26-15/16" (68,3 cm) 29-15/16" (76 cm) 35-5/8" (90,4 cm) 22-1/16" (56,1 cm) mín, 6" (15,2 cm) máx, 11-1/2" (29,2 cm) mín, 4" (10 - Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 22
- Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 23
- Viking VMOS | 27 inchW. Professional Built-in Trim Kit - VMTK272 - Installation - Page 24
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For more product information, call 1-888-845-4641 TINSLB035MRR1
Installation Guide
Microwave Built-In Trim Kit