Viking VWH560481 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc
Viking VWH560481 Manual
View all Viking VWH560481 manuals
Add to My Manuals
Save this manual to your list of manuals |
Viking VWH560481 manual content summary:
- Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 1
30" TO 66" WIDE, 9" TO 18" HIGH. READ AND SAVE THESE INSTRUCTIONS WARNING TO REDUCETHE RISK OF FIRE,ELECTRIC SHOCK,OR INJURY TO PERSONS, OBSERVE THE Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting This Manual With The Homeowner HOMEOWNER: Use - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 2
corner, mark the rectangular cutout (22" W x 29½" H) and remove only the siding in this area. C. Mark an 11" diameter hole centered on the guide hole. Cut this hole through the roof board(s). D. Mark and cut a 1¼" diameter hole through the roof board(s) where shown. 4. For flat roof installations - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 3
INstall the VENTILATOR ROOF INSTALLATIONS 1. Remove the cover and screws. 2. Attach an appropriate U.L. approved cable connector in the hole at the rear of the wiring box. 3. Remove roofing nails from shingles around the TOP and SIDES of the cutout area only. Carefully lift the shingles to allow the - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 4
performance, use the straightest possible duct run and the fewest number of elbows. Tape all joints. 2. Run 120 VAC electrical power cable from service panel and from remote ventilator to installation location. 3. Remove wiring box cover. Remove knockouts from the wiring box. Feed 6" of power cable - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 5
MODÈLE DEV1200 VENTILATEUR MONTÉ À L'EXTÉRIEUR POUR UTILISATION AVEC LES HOTTES DE CUISINE :-/-2+6%2+)00'VCWH, VICH, DBCV, DICV, DCWH, DCWL, DCWN, DTWS, ET DCIH, DE 30" À 66" (76,2 CM À 167,6 CM) DE LARGEUR, 9" À 18" (22,9 CM À 45,7 CVM)EDEUHAIULTELURE. Z LIRE CES DIRECTIVES ET LES CONSERVER - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 6
¼u "d'udniad.iahmoèltere de 3,2cm(1¼po) 32,2 cm ERNELMEVOEZVELESS HBAINRGDELAEUSX (121-1211/116/1p6o") 21,5"cm (1 po) (25022-1,01/2½cpm"o) Guide hole betTw((rccoeepueneondtunrettéergreeraulneleiftddtrseee) rs) D1i1a"mèdtirae .de 27,h9comle(11po) 9241,39/ 1c6m" (9-13/16 po) 451,78c"m (18 po - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 7
POSE Du ventilateur POSES SUR LES TOITS 1. Retirez le couvercle et les vis. 2. Fixez un connecteur de câble homologué U.L.dans l'ouverture à l'arrière du boîtier de câblage. 3. Retirez seulement les clous à toiture des bardeaux qui se trouvent sur le DESSUS et sur les CÔTÉS de la surface de découpe. - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 8
POSE DE LA PLAQUE DE RACCORDEMENT 1. Faites cheminer les conduits ronds en acier de 25,4 cm (10 po) du ventilateur extérieur vers l'emplacement de pose. Pour un meilleur rendement, utilisez le conduit rond le plus droit possible et réduisez au maximum l'utilisation de coudes. Guipez tous les joints. - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 9
una cubierta tipo isla) VENTILADOR EXTERIOR MODELO DEV1200 INSTALACIÓN TÍPICA DE MONTAJE EN EL TECHO INSTALACIÓN TÍPICA DE MONTAJE EN LA PARED INSTALADOR: Entregue este manual al dueño de la casa DUEÑO DE LA CASA: Las instrucciones de uso y cuidado se encuentran en la página 12. - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 10
PREPARE EL LUGAR DE LA INSTALACIÓN INSTALACIONES EN EL TECHO 1. Ubique el ventilador en la pendiente posterior del techo. Colóquelo en un área en la cual minimice la longitud del tramo de conducto. Esta área debe estar libre de obstáculos (cables de T.V., cables eléctricos, etc.). Si la parte - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 11
INSTALE EL VENTILADOR INSTALACIONES EN EL TECHO 1. Quite la cubierta y los tornillos. 2. Coloque un conector de cables apropiado, aprobado por U.L., en el orificio que se encuentra en la parte posterior de la caja de conexiones. 3. Quite los clavos de las tablas del techo de las tejas solamente - Viking VWH560481 | 1200 CFM Exterior-Power Ventilator Kit - Installation Instruc - Page 12
INSTALE LA PLACA DE EMPALME 1. Tienda los conductos de acero redondos de 10 pulg. (25 cm) desde el ventilador exterior hasta el sitio de la instalación. Para un mejor rendimiento, use el tendido de tubería más recto posible y el menor número de codos. Ponga cinta en todas las uniones. 2. Tienda un
READ AND SAVE THESE INSTRUCTIONS
MODEL DEV1200
EXTERIOR MOUNTED VENTILATOR
FOR USE WITH
CWH, VICH, DBCV, DICV, DCWH, DCWL, DCWN, DTWS AND
DCIH
RANGE
HOODS. 30" TO 66" WIDE, 9" TO 18" HIGH.
WARNING
TO REDUCETHE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1.
Use this unit only in the manner intended by the manu-
facturer. If you have questions, contact the manufacturer
or your distributor.
2.
Before servicing or cleaning unit, switch power off at
service panel and lock the service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
3.
Installation work and electrical wiring must be done by
a qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction
codes and standards.
4.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent backdrafting. Follow the
heating equipment manufacturer's guideline and safety
standards such as those published by the National
Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
CAUTION
1.
For general ventilating use only. Do not use to exhaust haz-
ardous or explosive material and vapors.
2.
To avoid motor bearing damage and noisy and/or unbalanced
impellers,keepdrywallspray,constructiondust,etc.offpower
unit.
3.
Please read specification label on product for further informa-
tion and requirements.
4.
Electrical circuit, including speed control, (if used), must be
rated 6 AMPS minimum.
PLAN THE
INSTALLATION
1.
Locate the ventilator so
the length of the duct run
and number of elbows
needed are kept to a
minimum.
2.
Where possible, ventila-
tor should be centered
betweenwallstudsorroof
rafters.
3.
Avoid pipes, wires, or
other ductwork that may
be running through the
wall.
ALL
INSTALLATIONS
MODEL
VOLTS
AMPS
CFM
DUCT SIZE
DEV1200
120
3.0
1200
10" DIA.
SPECIFICATIONS
INSTALLER: Leave This Manual With The Homeowner
HOMEOWNER: Use And Care Information On Page 4
TYPICAL ROOF MOUNTED INSTALLATION
TYPICAL WALL MOUNTED INSTALLATION
5.
When cutting or drilling into wall, or ceiling, do not dam-
age electrical wiring or other hidden utilities.
6.
Ducted fans must always be vented to the outdoors.
7.
To reduce risk of fire, use only metal ductwork.
8.
This unit must be grounded.
WARNING
MODEL DEV1200
EXTERIOR VENTILATOR
10" ROUND
DUCT
SOFFIT
WALL HOOD
CANOPY
(island canopy available)
MODEL
DEV1200
EXTERIOR
VENTILATOR
10" ROUND DUCT
SOFFIT
10" ROUND ELBOW
WALL HOOD
CANOPY
(island canopy available)
Blower Dimensions
22 x 30.828 x 12.724