Viper 3105V Owner Manual - Page 16

Panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote. Press for approximately two seconds, to enter Panic Mode. The siren sounds and the parking lights flash for the programmed siren duration. To stop Panic Mode at any time, press the . Valet mode You can prevent your security system from automatically arming and triggering by using Valet Mode. This is very useful when washing the vehicle or having it serviced. In Valet Mode, the security system will not arm, even with the remote transmitter, but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet switch within 10 seconds. The status LED lights solidly if you are entering Valet Mode, and goes out if you are exiting Valet Mode. To enter or exit Valet Mode with the remote: Open any vehicle door, and then quickly press the following buttons in the sequence indicated. 4. Press . 5. Press AUX and then press again. The in - vehicle status LED lights solidly if you are entering Valet Mode, and goes out if you are exiting Valet Mode. © 2012 Directed. All rights reserved. 13