Vtech CS6329 User Manual - Page 20

Answering system settings Remote access code A two-digit security code is required to access the answering system remotely from any touch-tone telephone. The preset code is 19. You can set the code from 00 to 99. 1. Press MENU/SELECT when the handset is not in use. 2. Press VOL/ or VOL/CID to select >Answering Sys, then press MENU/SELECT. 3. Press VOL/ or VOL/CID to select >Ans sys setup, then press MENU/SELECT. 4. Press VOL/ or VOL/CID to select >Remote code, then press MENU/SELECT. 5. Press the dialing keys (0-9) to enter the code or VOL/ or VOL/CID to select from 00 to 99, then press MENU/SELECT to confirm. Message alert tone This telephone can beep every 10 seconds to alert you of new messages. The tone stops when all new messages have been reviewed. 1. Press MENU/SELECT when the handset is not in use. 2. Press VOL/ or VOL/CID to select >Answering Sys, then press MENU/SELECT. 3. Press VOL/ or VOL/CID to select >Ans sys setup, then press MENU/SELECT. 4. Press VOL/ or VOL/CID to select >Msg alert tone, then press MENU/SELECT. 5. Press VOL/ or VOL/CID to select from On or Off, then press MENU/SELECT to confirm your selection. • The answering system must be turned on for the message alert tone to function. • Press any key on the telephone base (except /FIND HANDSET) to temporarily silence the message alert tone. Announcement The telephone is preset with a greeting that answers calls with "Hello, please leave a message after the tone." You can use this preset announcement, or replace it with your own. 16