Vtech CS6329 User Manual - Page 8

Getting started Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 45 for battery operating times. If the screen is blank, you need to charge the handset without interruption for at least 10 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset beeps four times every minute, shows LOW BATTERY and a flashing icon. If you are on a call in low battery mode, the handset has four short beeps to alert you. The following table summarizes the battery charge indicators and actions to take. Battery indicators Battery status The screen is blank. Battery has no charge and the handset cannot be used. The screen shows Battery has very little PLACE IN CHARGER charge and the handset and flashes. cannot be used. The screen shows LOW BATTERY and flashes. The handset beeps four times every minute. Battery has enough charge to be used for a short time. The screen shows HANDSET X. Battery is charged. Action Charge without interruption (at least 10 minutes). Charge without interruption (at least four minutes). Charge without interruption until the screen shows HANDSET X (about 30 minutes). To keep the battery charged, place it in the telephone base or charger when not in use. If you do not plug in the battery into the handset and place it in the telephone base or charger, the screen displays NO BATTERY.