Vtech CS6429-2 User Manual (CS6429-2 User Manual) - Page 56

Replace a handset, To deregister all handsets, FIND HANDSET, IN USE, PRESS FIND HS ON BASE 4 SEC - reset

Get Vtech CS6429-2 PDF manuals and user guides
UPC - 735078019998
View all Vtech CS6429-2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

Appendix Replace a handset If you want to replace a handset or reassign the designated handset number of a registered handset, you must deregister all the handsets and then individually register each handset. To make deregistration easier, read all of the instructions below before you begin. To deregister all handsets: 1. Press and hold /FIND HANDSET on the telephone base for about 10 seconds until the IN USE light on the telephone base turns on and starts to flash. 2. Press and release /FIND HANDSET again. You must press /FIND HANDSET while the IN USE light is still flashing. The IN USE light flashes for approximately five seconds. If the light stops flashing, start again at Step 1. 3. All handsets show 1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON HANDSET alternately when the deregistration process completes. The deregistration process takes about 10 seconds to complete. If deregistration fails, you may need to reset the telephone and try again. To reset: 1. Pick up the registered handset and then press /FLASH. 2. Press OFF/CANCEL and place the handset back in the telephone base. -OR• Unplug the power from the telephone base, then plug it back in. You cannot deregister handsets if any other system handset is in use. 52

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
52
Replace a handset
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all the handsets and then individually
register each handset.
To make deregistration easier, read all of the instructions below before you begin.
To deregister all handsets:
Press and hold
/FIND HANDSET
on the telephone base for about 10 seconds
until the
IN USE
light on the telephone base turns on and starts to flash.
Press and release
/FIND HANDSET
again. You must press
/FIND HANDSET
while the
IN USE
light is still flashing. The
IN USE
light
flashes for approximately five seconds. If the light stops flashing, start again at
Step 1.
All handsets show
1.PRESS FIND HS ON BASE 4 SEC
and
2.THEN PRESS
# ON HANDSET
alternately when the deregistration process completes. The
deregistration process takes about 10 seconds to complete.
If deregistration fails, you may need to reset the telephone and try again.
To reset:
Pick up the registered handset and then press
/
FLASH
.
Press
OFF/
CANCEL
and place the handset back in the telephone base.
-OR-
Unplug the power from the telephone base, then plug it back in.
1.
2.
3.
1.
2.
•
You cannot deregister handsets if any other system handset is in use.
You cannot deregister handsets if any other system handset is in use.
Appendix