Vtech TL7610 Quick Start Guide

Vtech TL7610 Manual

Vtech TL7610 manual content summary:

  • Vtech TL7610 | Quick Start Guide - Page 1
    Quick start guide TL7610/TL7611 DECT 6.0 cordless headset
  • Vtech TL7610 | Quick Start Guide - Page 2
    and p��la��c�e��t�h�e��w��ir�e�s��n��e�a�t�ly��i�n�s�i�d�e� the compartment. 4. Insert the tab on the bottom of the battery cover into the battery compartment. Press down gently on the battery cover until it snaps into place. NOTE: Remove the ear hook from the headset before battery replacement. 
  • Vtech TL7610 | Quick Start Guide - Page 3
    the headset into the headset base. 2. Push the headset downward until the ON/OFF light on the headset turns on. IMPORTANT INFORMATION Use only the supplied rechargeable battery or replacement battery (model BT191545). To obtain a replacement battery, call 1 (800) 222-3111. In Canada, dial 1 (866
  • Vtech TL7610 | Quick Start Guide - Page 4
    ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. For customer service or product information, visit our website at www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. Avoid placing the headset base
  • Vtech TL7610 | Quick Start Guide - Page 5
    model TL7611, see the TL7000 handset lifter manual for installation instructions. Optional accessories It is recommended that you install a handset lifter (model TL7000) and/or a dial pad (model TL7601) with your headset. The following optional accessories are compatible with your headset and
  • Vtech TL7610 | Quick Start Guide - Page 6
    installation instructions in the TL7000 handset lifter manual and then proceed on page 10 of this quick start guide. If you purchased model TL7610 (without handset lifter), you have three installation options: Option 1: Use the headset with a single standard telephone line with a corded or cordless
  • Vtech TL7610 | Quick Start Guide - Page 7
    base: Remove the rear bottom piece of the headset base by pushing it away from the base (as shown in Figure 1). Figure 1 Install the headset base as shown on the following pages. After completing installation option 1 or 2: Slide the rear bottom piece towards the base until it clicks into place
  • Vtech TL7610 | Quick Start Guide - Page 8
    cordless phone installation (TL7610) 1. Plug the small end of the headset base power adapter into the POWER jack (green dot) at the back of the headset DSL Internet service). 6. Plug the headset base power adapter into an electrical outlet not controlled by a wall switch. Cordless or corded
  • Vtech TL7610 | Quick Start Guide - Page 9
    cord into a telephone jack. 4. Plug the headset base power adapter into an electrical outlet not controlled by a wall switch. DSL filter (not included) required if you have DSL high-speed Internet service. NOTE: For more information about the accessory dial pad (model TL7601), visit our website
  • Vtech TL7610 | Quick Start Guide - Page 10
    TL7610) With this installation, you can make and receive calls using the LIFTER MODE without a lifter. 1. Plug the small end of the headset ) jack on DSL filter (not included) required the headset base. if you have DSL high-speed Internet service. 7. Plug the other end of the telephone line
  • Vtech TL7610 | Quick Start Guide - Page 11
    of the headset to adjust the listening volume when on a call. MUTE/FLASH Press to mute the microphone during a call. Press and hold to receive call waiting during a call. Press to mute the ring tone in the earpiece when there is an incoming call. Battery cover Open to install or replace the battery
  • Vtech TL7610 | Quick Start Guide - Page 12
    light On when the LIFTER MODE is selected. Flashes while on a call. Flashes quickly when there is an incoming call. MUTE light On when the call is muted. For complete instructions, please refer to the user's manual. If you are unable to find your manual, please visit www.telephones.att.com to read
  • Vtech TL7610 | Quick Start Guide - Page 13
    Getting started Quick reference guide - headset base LIFTER AUDIO ADJUST Adjust the switch to choose the best headset audio quality when using a handset lifter. (See the handset lifter user's manual for more information. You may download the manual at www.telephones.att.com.) VOLUME Press the volume
  • Vtech TL7610 | Quick Start Guide - Page 14
    www.telephones.att.com © 2008 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property II, L.P. d/b/a AT&T Intellectual Property licensed to Advanced American Telephones. Printed in China. Issue 1 AT&T 07/08.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

Quick start guide
TL7610/TL7611
DECT 6.0 cordless headset