Vtech V.Flash Home Edutainment Learning System User Manual - Page 10
System Operation - review
View all Vtech V.Flash Home Edutainment Learning System manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
SYSTEM OPERATION SYSTEM OPERATION TO BEGIN PLAY • Make sure the unit is turned OFF. • Press the EJECT button to open the Main Unit cover. • Place the V.DISC™, label and printed side up, into the disc compartment and onto the center hub. • Close the Main Unit cover. • Turn your TV on. • Set your TV input mode to accept input from the port to which V.FLASHTM is connected. In many cases this will involve setting the TV to " video" mode; however, since all TVs vary, please refer to your TV or VCR manual for further details. • Make sure that both the Controller and AC adaptor are properly plugged into the console and the wall outlet. • Turn the V.FLASHTM Home Edutainment System on by pressing the ON button. Enjoy your game! • When not using your V.FLASHTM, press the OFF button and EJECT button to remove the V.DISC™. • Close the Main Unit cover. NOTE: • If you don't see the V.FLASHTM logo screen on your TV, please review the above. If there is still no picture on TV, press the RESTART button and wait for a few seconds then press ON button again. Please refer to Troubleshooting table for more information. • Do not accidentally press the RESTART button while playing a game, or the game will restart. TO CHANGE A V.DISC™ • While the power is ON, press the OFF button to stop the game play. • Press the EJECT button to open the Main Unit cover and remove the V.DISC™ from the console. • Place another V.DISC™, label and printed side up, into the disc compartment and onto the center hub. • Close the Main Unit cover. • Press the ON button and start to play. 7