Vtech V.Reader & MobiGo Car Charger User Guide

INSTRUCTIONS

Thank you for purchasing the VTech

®

Car Adaptor. Be sure to read and follow all

instructions carefully before using this product.

1. Plug the adaptor connector into your

car’s accessory socket.

2. Plug the other end into the DC power

jack of your VTech

®

product.

NOTE: The car adaptor does not charge the

batteries in your VTech

®

product . It simply acts

as an alternative source of power.

CARE & MAINTENANCE

Important Safety Instructions

1. SAVE THESE INSTRUCTIONS - This manual contains important safety and operating

instructions for the car adaptor.

2. Before using the car adaptor, read all instructions and cautionary markings on the

adaptor.

3. Use of an attachment not recommended or sold by the car adaptor manufacturer

may result in a risk of fire, electric shock, or injury to persons.

4. To reduce the risk of damage to the adaptor and cord, pull by the adaptor connector

rather than by the cord when disconnecting the adaptor.

5. Make sure the cord is positioned so that it will not be stepped on, tripped over, or

otherwise subjected to damage or stress.

6. Do not operate the car adaptor with a damaged cord. Replace it immediately.

7. Do not operate the car adaptor if it has received a sharp blow, been dropped, or

otherwise damaged in any way.

8. To reduce the risk of electric shock, unplug the adaptor before attempting any

maintenance or cleaning. Turning off the power will not reduce this risk.

WARNING:

Do not expose the car adaptor to rain, moisture, or snow.

Adult Supervision Required.

TECHNICAL SUPPORT

DISCLAIMER AND LIMITATION OF LIABILITY

NOTE:

If you have a problem that cannot be solved by using this manual, we encourage you

to visit us online or contact our Consumer Services Department with any problems

and/or suggestions that you might have. A support representative will be happy to

assist you.

Before requesting support, please be ready to provide or include the information

below:

• The name of your product or model number (the model number is typically located

on the back or bottom of your product).

• The actual problem you are experiencing.

• The actions you took right before the problem started.

Internet: www.vtechkids.com

Phone: 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada

VTech

®

Electronics North America, L.L.C. and its suppliers assume no responsibility

for any damage or loss resulting from the use of this handbook.

VTech

®

Electronics

North America, L.L.C. and its suppliers assume no responsibility for any loss or

claims by third parties that may arise through the use of this software.

VTech

®

Electronics North America, L.L.C. and its suppliers assume no responsibility for any

damage or loss caused by deletion of data as a result of malfunction, dead battery,

or repairs. Be sure to make backup copies of important data on other media to

protect against data loss.

COMPANY :

VTech

®

Electronics North America, L.L.C.

ADDRESS : 1156 W. Shure Drive, Suite 200, Arlington Heights, IL 60004

TEL NO.: 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution:

Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

©

2012 VTech

Printed in China

91-002088-878

Adaptor’s technical

specifications:

Input Voltage = 12V DC 0.4A

Output Voltage = 7.5V DC

Max Current = 400mA

Polarity :

US

Vtech V.Reader & MobiGo Car Charger User Guide

Vtech V.Reader & MobiGo Car Charger Manual

Vtech V.Reader & MobiGo Car Charger manual content summary: