Vtech VH6210 Headset connection methods - Option 3 Connect to a traditonal cor
Vtech VH6210 Manual
 |
View all Vtech VH6210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Vtech VH6210 manual content summary:
- Vtech VH6210 | Headset connection methods - Option 3 Connect to a traditonal cor - Page 1
VH6210 VH6211 Option 3: Connect to a traditional corded phone with Lifter Make sure the headset battery is well charged (with headset LED in purple) or fully charged (with headset LED in blue). 1. Plug the end of the corded phone connection cable labelled into the PHONE jack (blue dot) at the rear - Vtech VH6210 | Headset connection methods - Option 3 Connect to a traditonal cor - Page 2
a dial tone. If there is no dial tone or the dial tone is unclear, slide the corded handset audio switch at the bottom of the headset base from A to F until the dial tone is clear. Adjust the switch hook presser position Turn the knob to move the switch hook presser until - Vtech VH6210 | Headset connection methods - Option 3 Connect to a traditonal cor - Page 3
the center of the corded phone speaker. Ring detector on/off When the ring detector detects an incoming call, it sends a ring tone to the headset earpiece. • Press the RING ON/OFF button on the lifter to turn the ring detector on or off. The STATUS light is blue when the
-
1 -
2 -
3
 |
 |
Option 3: Connect to a traditional corded phone with Lifter
Make sure the headset battery is well charged (with headset LED in purple)
or fully charged (with headset LED in blue).
Plug the end of the corded phone connection cable labelled
into the
PHONE
jack (blue dot)
at the rear of the headset base.
Plug the curly handset cord of the corded phone into the adapter jack at
the center of the corded phone connection cable.
Plug the end of the corded phone connection cable labelled
into the corded
handset jack on the corded phone.
Install the lifter on your telephone.
a)
Look at the space underneath the corded handset. If there is a
speaker, the lifter should be centered over the speaker. If there is
no speaker, the lifter should be centered within the space.
b)
Make sure the switch hook is pressed down. Check if the lifter arm
is raised above the switch hook of the telephone base by pressing
on the headset to take the line.
c)
Peel off the protective strips from the adhesive tape at the lifter.
d)
Carefully place the lifter in the desired position and press down.
Flip open the
LIFTER
jack cover at the rear of the headset base. Plug
the end of the lifter control cable into the
LIFTER
jack.
Read the following two pages to adjust the lifter’s positions and audio
options before you install the corded handset lifter on the corded phone.
To test the headset and lifter after connection:
Press the
ON�OFF
ON�OFF
button
on headset. The lifter’s switch hook presser rises and releases the switch hook. You hear a dial tone in the headset earpiece.
1.
2.
3.
4.
5.
6.
VH6210
VH6211