Weber Platinum I 2200 LP Owner Manual

Weber Platinum I 2200 LP Manual

Get Weber Platinum I 2200 LP PDF manuals and user guides View all Weber Platinum I 2200 LP manuals
Add to My Manuals
Save this manual to your list of manuals

Weber Platinum I 2200 LP manual content summary:

  • Weber Platinum I 2200 LP | Owner Manual - Page 1
    with the factory. PLATINUM™ 2200 Series Natural Gas Barbecue Owner's Manual ® ® PSLEARTIIENSUM ® WARNING: Follow all leak check procedures carefully in this manual prior to barbecue operation. Do this even if barbecue was dealer assembled. NOTICE TO INSTALLER: These instructions must be left
  • Weber Platinum I 2200 LP | Owner Manual - Page 2
    using. See instructions in this manual for correct procedures. ƽ Do not operate the Weber Gas Barbecue if there is a gas leak present. ƽ Do not use a flame to check for gas leaks. ƽ Combustible materials should never be within 24 inches of the top, bottom, back or sides of your Weber Gas Barbecue
  • Weber Platinum I 2200 LP | Owner Manual - Page 3
    Weber Gas Barbecue that it will be free of defects in material and workmanship from the date of purchase as follows: Aluminum Castings, 10 years, Cooking Grates and Flavorizer Bars, 3 years, All Remaining Parts, 5 years, when assembled and operated in accordance with the printed instructions manual.
  • Weber Platinum I 2200 LP | Owner Manual - Page 4
    PATENTS AND TRADEMARKS © 1997 Weber. Weber, , Flavorizer and Crossover are registered U.S. trademarks; Platinum, Perma-Mount, Gas Catcher, FlameCheck, SteamN-Chips, Spider Stopper, and Warm-Up are U.S. trademarks of WeberStephen Products Co., 200 East Daniels Road, Palatine, IL 60067-6266. U.S.A.
  • Weber Platinum I 2200 LP | Owner Manual - Page 5
    Instructions 6 Assembly 7-21 Operating Instructions Lighting 22-23 Cooking 24 Storage and/or Nonuse 24 Cleaning 24 Troubleshooting & Maintenance Annual Maintenance 25 General Maintenance 26-28 Troubleshooting . g) Crossover Ignition System with Gas Catcher Ignition Chamber. h) Catch pan catches
  • Weber Platinum I 2200 LP | Owner Manual - Page 6
    to use and gives you more cooking control than charcoal fuel. s These instructions will give you the minimum requirements for assembling your Weber Gas Barbecue. Please read the instructions carefully before using your Weber Gas Barbecue. Improper assembly can be dangerous. s Not for use by children
  • Weber Platinum I 2200 LP | Owner Manual - Page 7
    1 Check package contents Cooking box (assembly) Lid (assembly) ® ® Supplies needed You will need a soap and water solution to check for gas leaks. (See Step "Check for gas leaks.") Note - The hardware size of nuts, bolts and screws is given. For example "1/4-20 x 2 inch bolt" means a bolt 1/4 inch
  • Weber Platinum I 2200 LP | Owner Manual - Page 8
    cooking grates Warming rack Warm-Up Basket Thermometer Catch pan holder Manifold bracket Left hand slide bar assembly Assembly consists of: Left hand slide bar Support rod Slide 8
  • Weber Platinum I 2200 LP | Owner Manual - Page 9
    Right hand slide bar assembly Assembly consists of: Right hand slide bar Support rod Slide Check contents of hardware packs Three burner control knobs Three tool holders Four tubing plugs (two are spares) Two wheel hubcaps (actual size)
  • Weber Platinum I 2200 LP | Owner Manual - Page 10
    on the block of wood (or other protected surface). Tap on one hubcap. Put one wheel on the axle, WEBER side toward the hubcap. Slide the axle through the frame. Add the other wheel, WEBER side out. Tap on the hubcap. Figure 1. ER ER WE B Step 3 Assemble frame You will need: left frame, right
  • Weber Platinum I 2200 LP | Owner Manual - Page 11
    Step 4 Continue frame assembly You will need: frame assembly, wheel frame assembly, front panel, caster frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel
  • Weber Platinum I 2200 LP | Owner Manual - Page 12
    the frame brace. Figure 6. Burner tubes Frame brace Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame at the left rear and left front of the cooking box? The screws are only guides. Do not tighten. Figure 8 (b). c) Are the wing nuts under the burner assembly
  • Weber Platinum I 2200 LP | Owner Manual - Page 13
    as a unit and hook onto the frame brace. Manifold bracket Frame brace Step 9 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system. The igniter lock nut and igniter gasket are on the
  • Weber Platinum I 2200 LP | Owner Manual - Page 14
    manual shut-off valve indoors should be installed in the branch fuel line in an accessible location near the supply line. s The quick disconnect connects to a 3/8 inch NPT thread from the gas should be used for lengths greater than 50 feet. s Gas piping may be copper tubing, type K or L; polyethylene
  • Weber Platinum I 2200 LP | Owner Manual - Page 15
    burners have been flame tested. As a safety precaution you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may have loosened or damaged a gas fitting. ƽWARNING: Perform these leak checks even if your barbecue was dealer or store assembled. You will
  • Weber Platinum I 2200 LP | Owner Manual - Page 16
    checks are complete, turn gas supply OFF at the source and rinse connections with water. Step 14 Install Flavorizer Bars and Cooking Grates You will need: five long Flavorizer Bars, eight short Flavorizer Bars and two cooking grates. Set the long Flavorizer Bars side to side in the lower position
  • Weber Platinum I 2200 LP | Owner Manual - Page 17
    the hinge pins. Figure 21. Finger grip on front edge of bottom tray Front side of catch pan holder Figure 18 Hook the ends of the catch pan holder into Figure 19. The front of the catch pan holder must be on the same side as the finger grip of the bottom tray. Hair pin cotter Hinge pin Finger
  • Weber Platinum I 2200 LP | Owner Manual - Page 18
    screws, left hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers. Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 23 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 23 (b). The
  • Weber Platinum I 2200 LP | Owner Manual - Page 19
    pliers. Figure 25. Notch to the front Slide bar View from front of barbecue View from rear of barbecue Figure 25 To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 26. (c) Figure 24
  • Weber Platinum I 2200 LP | Owner Manual - Page 20
    screws, right hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers. Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 27 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 27 (b). The
  • Weber Platinum I 2200 LP | Owner Manual - Page 21
    and engage slide in locked position. Figure 30. Support rod Step 20 Complete accessory installation You will need and a hammer. Insert one end of the Weber Warm-Up Basket into the hole in the right Set the work tables onto the left and right side rails. Figure 31 (b). Set the accessory trays between
  • Weber Platinum I 2200 LP | Owner Manual - Page 22
    lighting instructions are on the control panel. ƽ DANGER Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to , turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match. 7) After the
  • Weber Platinum I 2200 LP | Owner Manual - Page 23
    control knobs are turned OFF. (Push each burner control knob down and turn clockwise.) 3) Turn gas supply valve on. 4) Strike a match and put the flame into the matchlight hole in the front of the cooking box. Manual Lighting 1 ƽWARNING: Do not lean over open barbecue. Keep your face and body at
  • Weber Platinum I 2200 LP | Owner Manual - Page 24
    at medium, CENTER off, and BACK at medium). See your Weber cookbook for detailed cooking instructions. Note: The temperatures inside your cooking box, for the in the bottom tray. Storage and/or Nonuse s When storing the Weber Gas Barbecue, make sure that the inside shut off valve and/or locking outdoor
  • Weber Platinum I 2200 LP | Owner Manual - Page 25
    Maintenance" section of this manual. s Check all gas fittings for leaks. ƽ DANGER Do not use an open flame to check for gas leaks. Be sure there are complete, turn gas supply OFF at the source and rinse connections with water. (a) (b) (c) Figure 3 Inspection and Cleaning of the Weber Spider Stopper
  • Weber Platinum I 2200 LP | Owner Manual - Page 26
    burner ports are fully open. Figure 8 ƽCAUTION: Do not enlarge the burner ports when cleaning. Replacing Main Burners a) Your Weber Gas Barbecue must be OFF and cool. b) Turn gas OFF at source. c) Remove control panel: take off the burner control knobs. Remove the screws holding the control panel in
  • Weber Platinum I 2200 LP | Owner Manual - Page 27
    . Figure 13a. Check proper assembly before fastening manifold in place. Figure 13b. (a) Valve Wing nuts Figure 10 f) Slide the burner assembly out from under the guide screw and washer in the corners of the cooking box. Figure 11
  • Weber Platinum I 2200 LP | Owner Manual - Page 28
    Stopper Guards do not fit tightly, contact your dealer. ƽWARNING: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. (See the Crossover Ignition System still fails to light, see Section "Manual Lighting", and contact your dealer. 28
  • Weber Platinum I 2200 LP | Owner Manual - Page 29
    TROUBLESHOOTING Problem Check Burners burn with a yellow or orange flame, in Inspect Weber Spider Stopper conjunction with the smell of gas. Guards for possible obstructions. (Blockage of holes.) Cure Clean Weber Spider Stopper Guards. (See Section "Annual Maintenance".) Burner does not
  • Weber Platinum I 2200 LP | Owner Manual - Page 30
    1 2 3 4 5 6 7 8 9 10 11 12 13 14 15-16 17 18-19, 16 10 20 21 22-23 24 25 26 ® ® E BE R W E BE R W 27 28 29 30 18 19 31 32 33 16 34 30 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 8 51 52 60 53-58 12 14 59
  • Weber Platinum I 2200 LP | Owner Manual - Page 31
    Have your owner's manual and serial number of the barbecue available for reference. Weber-Stephen Products Company Customer Service Center 250 South 57 Igniter wire (white) 58 Gas catcher ignition chamber 59 Hose 60 Control panel inserts (2) ṇWARNING: Use only Weber factory authorized parts. The use
  • Weber Platinum I 2200 LP | Owner Manual - Page 32
    problems with parts or assembly. Call our toll free number 1-800-446-1071. For quicker service, please have your owner's manual available for reference. We also welcome any comments or suggestions you might have regarding our products. We wish your family the best in outdoor cooking enjoyment. Weber
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Serial Number
Please use this number in registering your warranty
and any correspondence with the factory.
®
®
P
LATINUM
SERIES
98835
11/97
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
WARNING: Follow all leak check procedures
carefully in this manual prior to barbecue
operation. Do this even if barbecue was
dealer assembled.
PLATINUM
™
2200 Series
Natural Gas Barbecue
Owner's Manual
®
WARNING: Do not try to light this appliance
without reading "Lighting" instructions
section of this manual.
FOR YOUR SAFETY
If you smell gas:
1.
Shut off gas to the appliance.
2.
Extinguish any open flame.
3.
Open lid.
4.
If odor continues, immediately call your
gas supplier.