Weider Gym 4000 Uk Manual
Weider Gym 4000 Manual
 |
View all Weider Gym 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Weider Gym 4000 manual content summary:
- Weider Gym 4000 | Uk Manual - Page 1
House 223 North Street Sheepscar West Yorkshire Leeds LS7 2AA CAUTION Read all precautions and instructions in this manual before using this equipment. Save this manual for future reference. USERʼS MANUAL Visit our website at www.weslo.com new products, prizes, fitness tips, and much more! - Weider Gym 4000 | Uk Manual - Page 2
16 WEIGHT RESISTANCE CHART 17 TROUBLE-SHOOTING AND MAINTENANCE 18 CABLE DIAGRAM 19 PART IDENTIFICATION CHART End of Manual PART LIST End of Manual EXPLODED DRAWING End of Manual HOW TO ORDER REPLACEMENT PARTS Back Cover WESLO is a registered trademark of ICON Health & Fitness, Inc. 2 - Weider Gym 4000 | Uk Manual - Page 3
gym system are adequately informed of all precautions. 2. Read all instructions in this manual and in the accompanying literature before using the home gym system gym system. If the decal is missing or illegible, please call our Customer Service health problems. Read all instructions before using - Weider Gym 4000 | Uk Manual - Page 4
, or improve your cardiovascular system, the WESLO® GYM 4000 will help you to achieve the specific results you want. For your benefit, read this manual carefully before using the home gym system. If you have additional questions, please call our Customer Service Department at 0345-089009. To - Weider Gym 4000 | Uk Manual - Page 5
assembly, use the PART IDENTIFICATION CHART located in the centre of this manual. Note: Some small parts may have been preattached for shipping. If the home gym system, be sure that all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do - Weider Gym 4000 | Uk Manual - Page 6
2. Slide the Front Upright (42) onto the 5/16" x 2 2 1/2" Carriage Bolts (1) in the Base (4). Hand tighten a 5/16" Nylon Locknut (3) onto each Carriage Bolt. Do not tighten the Nylon Locknuts yet. 42 FRAME ASSEMBLY 3 4 1 3. Press a 2" Square Inner Cap (27) into the open end of the Top Frame - Weider Gym 4000 | Uk Manual - Page 7
5/16" Nylon Locknut (3). Be sure that the Pulley Bracket (20) is in front of the Weight Guide (62) as shown. 61 3 55 60 20 62 7. Press a 1" x 7/8" Plastic Bushing on the Base (4). Note: This will be a tight fit. The Plastic Bushings should fit onto each end of the indicated tube in the Base - Weider Gym 4000 | Uk Manual - Page 8
8. Press a 1 3/4" Square Inner Cap (44) into the top of a Press Arm (46). Wet the handle on the Press Arm with soapy water. Slide a Handgrip (31) onto the handle. Press a 1" Round Inner Cap (49) into the other end of the handle. Attach the Press Arm to one side of the Press Frame (17) with two 5/16" - Weider Gym 4000 | Uk Manual - Page 9
11. Press a 1 3/4" Square Inner Cap (44) into the 11 Seat Frame (36). Attach a Bumper (73) to the Seat Frame with a 1/2" Tap Screw (65). Slide the Seat Frame (36) onto the 5/16" x 2 1/2" Carriage Bolts (1) in the Base (4). See the inset drawing. The bracket on the Seat Frame must be behind - Weider Gym 4000 | Uk Manual - Page 10
CABLE ASSEMBLY 14. During steps 15 through 29, refer to the CABLE DIAGRAM on page 19 of this manual to verify proper cable routing. Before beginning this section, identify the Long Cable (23) and the Short Cable (58) by comparing the lengths of the - Weider Gym 4000 | Uk Manual - Page 11
CABLE ASSEMBLY 18. Route the Long Cable (23) around the "V"- 18 Pulley (6) on the Right Arm (48). Be sure that the Cable is in the groove of the "V"- Pulley and that the Long Cable Trap (50) is turned to hold the Cable in place. Tighten the 3/8" x 2 1/2" Bolt (7) and the 3/8" Nylon Locknut ( - Weider Gym 4000 | Uk Manual - Page 12
CABLE ASSEMBLY 22. Locate the Short Cable (58). Route the 22 Short Cable under the 3 1/2" Low Pulley (77). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the welded spacer on the Leg Lever (29). Tighten the - Weider Gym 4000 | Uk Manual - Page 13
26. Note: The 3 1/2" Pulley (15) labelled in this step is pre-attached. It is shown removed for easy part identification. Route the Short Cable (58) around the 3 1/2" Pulley (15) attached to the upper hole in the Press Frame (17). Be sure that the Cable is routed around the Pulley as shown. Tighten - Weider Gym 4000 | Uk Manual - Page 14
CABLE ASSEMBLY 29. Attach the Long Cable (23) to the Small "U"- 29 Bracket (67) with a 1/4" Nylon Locknut (2) and a 1/4" Flat Washer (10). Do not com- pletely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing. - Weider Gym 4000 | Uk Manual - Page 15
all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 16 of this manual. Before using the home gym system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not - Weider Gym 4000 | Uk Manual - Page 16
Adjustment The instructions below describe how each part of the home gym system can be adjusted. IMPORTANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct starting position for the - Weider Gym 4000 | Uk Manual - Page 17
at each weight station may vary due to differences in individual weight plates, as well as friction between the cables, pulleys, and weight guides. WEIGHT PLATES PRESS ARM (lbs.) BUTTERFLY ARM (lbs.) LEG LEVER (lbs.) HIGH PULLEY (lbs.) LOW PULLEY (lbs.) LEG PRESS (lbs.) Top 13 1 36 - Weider Gym 4000 | Uk Manual - Page 18
Trouble-shooting and Maintenance Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild non- , see ORDERING REPLACEMENT PARTS on the back cover of this manual. 66 57 21 12 2 58 18 - Weider Gym 4000 | Uk Manual - Page 19
to be sure that the two cables and the cable traps have been assembled correctly. If the cables have not been correctly routed, the home gym system will not function properly and damage may occur. The numbers show the correct route for each cable. The starting and ending points of each cable - Weider Gym 4000 | Uk Manual - Page 20
1/4" Flat Washer (10) 5/16" Flat Washer (8) 3/8" Flat Washer (9) 5/16" x 1 3/4" Bolt (72) 5/16" x 2 1/2" Bolt (22) 5/16" x 2 3/4" Bolt (11) 1/4" x 3/4" Screw (18) 1/4" x 2 1/4" Screw (24) 5/16" x 2 1/2" Carriage Bolt (1) 5/16" x 2 3/4" Carriage Bolt (14) 1/4" x 2 1/2" Screw (43) 1/4" x 2 1/2" - Weider Gym 4000 | Uk Manual - Page 21
5/16" Nylon Locknut (3) 3/8" Nylon Locknut (21) 3/8" Nylon Jam Nut (33) 1/4" Nylon Locknut (2) 3/8" x 8" Bolt (59) 3/8" x 2" Bolt (12) 3/8" x 2 1/2" Bolt (7) 3/8" x 3 1/4" Bolt (35) 3/8" x 3 1/2" Bolt (16) 3/8" x 3 3/4" Bolt (71) Cable Clip (53) 1" Retainer (69) - Weider Gym 4000 | Uk Manual - Page 22
1/2" x 3/4" Spacer (61) 3/4" Round Inner Cap (34) 1" x 7/8" Plastic Bushing (75) 1" Round Inner Cap (49) 1" Inner Cap (81) 1" Round Cover Cap (70) 1 3/4" Square Inner Cap (44) 2" Square Inner Cap (27) 2" Square Outer Cap (51) - Weider Gym 4000 | Uk Manual - Page 23
8" Bolt 60 1 5/16" x 6" Bolt 61 2 1/2" x 3/4" Spacer 62 2 Weight Guide 63 1 Weight Tube 64 1 Weight Tube Bumper 65 2 #8 x 3/4" Tap Screw 66 6 Cable 1 Long Pad Tube 81 2 1" Inner Cap # 1 Userʼs Manual Note: "#" indicates a non-illustrated part. Specifications are subject to change - Weider Gym 4000 | Uk Manual - Page 24
Exploded Drawing-Model No. WLEMSY82000 R1000A 11 27 8 55 11 15 12 44 15 71 8 81 23 7 74 50 3 56 66 15 21 2 10 57 12 58 3 5 21 21 44 3 61 60 50 7 55 68 6 3 20 21 3 12 15 66 23 3 67 72 43 10 76 10 2 62 63 8 64 51 11 9 25 71 3 26 19 21 42 41 66 15 21 66 15 3 49 46 31 - Weider Gym 4000 | Uk Manual - Page 25
(WESLO® GYM 4000) 3. The SERIAL NUMBER of the product (see the front cover of this manual) 4. The KEY NUMBER and DESCRIPTION of the part(s) (see the PART LIST and EXPLODED DRAWING attached in the centre of this manual). Part No. 171109 R1000A Printed in Canada © 2000 ICON Health & Fitness, Inc
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
 |
 |
USERʼS MANUAL
QUESTIONS?
As a manufacturer, we are com-
mitted to complete customer sat-
isfaction. If you have questions,
or if there are missing/damaged
parts, we will guarantee you com-
plete satisfaction through direct
assistance from our factory.
Please CALL:
Or WRITE:
ICON Fitness Lifestyle Ltd.
Greenwich House
223 North Street
Sheepscar
West Yorkshire
Leeds LS7 2AA
Model No. WLEMSY82000
Serial No.
Write the serial number in the space
above for reference.
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
for future reference.
Serial Number Decal
Visit our website at
www.weslo.com
new products, prizes,
fitness tips, and much more!
0345-089009