Weider Pro 5500 User Manual - Page 9
Frame Assembly
View all Weider Pro 5500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Frame Assembly 1 1. Before beginning assembly, make sure you understand the information in the box on page 8. See the PART IDENTIFICATION CHARTS on pages 5 and 6 of this manual for help identifying small parts. Insert four M8 x 75mm Carriage Bolts (83) up through the Base (1). Note: It may be helpful to place a piece of tape over each Bolt head to hold it in place. 2 2. Insert an M8 x 75mm Carriage Bolt (83) up through the Stabilizer (3). Attach the Base (1) and the two Weight Guides (18) to the Stabilizer (3) with two M10 x 85mm Bolts (81), two M10 Washers (80), two 21mm Steel Spacers (108), two M10 Nylon Locknuts (77), and an M8 Nylon Locknut (78). Make sure the indicated holes in the Weight Guides are nearer the bottom. Do not tighten the Nylon Locknuts yet. Attach the Upright (2) to the Base (1) with the two indicated M8 x 75mm Carriage Bolts (83) and two M8 Nylon Locknuts (78). Do not tighten the Nylon Locknuts yet. 2 78 3. Attach the Front Leg (10) to the Base (1) with the 3 two M8 x 75mm Carriage Bolts (83) and two M8 Nylon Locknuts (78). Do not tighten the Nylon Locknuts yet. Attach the Leg Lever Bumper (75) to the Front Leg (10) with an M4 x 16mm Self-tapping Screw (110) and an M4 Washer (104). Make sure the end of the Leg Lever Bumper is pointing up. 1 83 83 18 Holes 78 77 78 1 83 80 81 80 83 108 3 75 104 110 78 10 78 83 1 9