Weider Pro 9930 User Manual - Page 15

29. Wrap the Long Cable (73) around a "V" Pulley (21) in 29 the direction shown. Attach the "V" Pulley and a Long Cable Trap (14) to the small tube on the Press Seat Frame (52) with a 3/8" x 3 1/4" Bolt (28), a 3/8" Flat Washer (17), and a 3/8" Nylon Locknut (4). Note: The small tube has three adjustment holes. Mount the "V" Pulley in the hole farthest from the Press Frame Upright (59). Make sure that the Cable Trap is oriented as shown. 4 17 14 59 52 21 28 30. Wrap the Long Cable (73) around a 3 1/2" Pulley (5) in the direction shown. Attach the Pulley and a Cable Trap (39) to the indicated hole in the Press Frame (53) with a 3/8" x 3 1/4" Bolt (28), a 3/8" Flat Washer (17), and a 3/8" Nylon Locknut (4). Make sure that the Pulley is mounted on the inside of the Press Frame and that the Cable Trap is oriented as shown. 30 17 28 53 73 73 4 5 39 31. Route the Long Cable (73) around a 3 1/2" Pulley (5) and back through the opening in the Press Frame 31 (53). 39 Remove the 3/8" Nylon Locknut (4) from the 3/8" x 4 3/4" Bolt (23) that was inserted in step 27. Attach the Pulley and a Cable Trap (39) to the Bolt and secure them with the Nylon Locknut. Make sure that the Cable Trap is oriented as shown. 5 23 53 4 73 32. Note: Lift the Top Weight (78) on the weight stack 32 in order to create slack in the Long Cable (73) before beginning this step. Attach the Long Cable (73) to the Leg Lever (49) by slipping the looped end of the Cable onto the looped end of the 3/8" x 2 1/2" Eyebolt (83). 83 49 73 15