Weider Pro 9930 User Manual - Page 6
Frame Assembly
View all Weider Pro 9930 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Frame Assembly 1 1. Before beginning, make sure that you have read and understood the information on page 5. Locate and open the parts bag labelled "FRAME ASSEMBLY." Press a 2" Square Inner Cap (38) into the Butterfly Base (61). Press two 2" Square Inner Caps into the Press Base (60). Insert four 5/16" x 2 1/2" Carriage Bolts (1) up 38 through the indicated holes in the Butterfly Base (61) and the Press Base (60). Note: If the Bolts fall out, secure them by putting a small piece of tape over the head of each Bolt. Place the Butterfly Base and the Press Base flat on the floor. 2 Attach the Press Base (60) to the Butterfly Base (61) with two 5/16" x 2 3/4" Bolts (20), two 5/16" Flat Washers (19), and two 5/16" Nylon Locknuts (2). 2. Position the Butterfly Upright (62) as shown. Place the bracket on the lower end of the Butterfly Upright over the indicated 5/16" x 2 1/2" Carriage Bolts (1) in the Butterfly Base (61). Hand tighten two 5/16" Nylon Locknuts (2) onto the Bolts. Do not tighten the Nylon Locknuts yet. 38 2 19 20 61 60 38 2 1 1 1 1 Position with the bracket on this side Place the bracket on the lower end of the Press 62 59 Frame Upright (59) over the indicated 5/16" x 2 1/2" Carriage Bolts (1) in the Press Base (60). Hand tight- en two 5/16" Nylon Locknuts (2) onto the Bolts. Do not tighten the Nylon Locknuts yet. 2 2 1 1 61 60 6