Weslo Cadence M6 Uk Manual

Weslo Cadence M6 Manual

Weslo Cadence M6 manual content summary:

  • Weslo Cadence M6 | Uk Manual - Page 1
    or write: ICON Health & Fitness, Ltd. Customer Service Department Unit 4 Revie Road Industrial Estate Revie Road Beeston Leeds, LS118JG UK email: [email protected] CAUTION Read all precautions and instructions in this manual before using this equipment. Save this manual for future reference. USER
  • Weslo Cadence M6 | Uk Manual - Page 2
    HOW TO FOLD AND MOVE THE TREADMILL 15 MAINTENANCE AND TROUBLESHOOTING 17 CONDITIONING GUIDELINES 19 ORDERING REPLACEMENT PARTS Back Cover Note: A PART IDENTIFICATION CHART, an EXPLODED DRAWING, and a PART LIST are attached in the center of this manual. WESLO is a registered trademark of ICON IP
  • Weslo Cadence M6 | Uk Manual - Page 3
    the power is turned off. Do not operate the treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See MAINTENANCE AND TROUBLESHOOTING on page 17 if the treadmill is not working properly.) 4. Keep the treadmill indoors, away from moisture and dust. Do not put
  • Weslo Cadence M6 | Uk Manual - Page 4
    adjustment procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only. 25. This treadmill is intended for in
  • Weslo Cadence M6 | Uk Manual - Page 5
    BEGIN Thank you for selecting the new WESLO® CADENCE M6 treadmill. The CADENCE M6 treadmill combines advanced technology with innovative design to make your workouts at home more effective and enjoyable. And when you're not exercising, the CADENCE M6 treadmill can be folded up, requiring less than
  • Weslo Cadence M6 | Uk Manual - Page 6
    parts during assembly, see the PART IDENTIFICATION CHART in the center of this manual. Some parts may be preassembled. 1. Make sure that the power cord is (52) is flat on the floor as shown. Position the front end of the treadmill Frame (51) between the Handrails (53, 54) as shown. Next, locate the
  • Weslo Cadence M6 | Uk Manual - Page 7
    (1), a Frame Washer (14), and a Handrail Star Washer (9). Do not tighten the Frame Pivot Bolts yet. Repeat this step on the left side of the treadmill. 54 11 14 1 9 51 4. Hold the Console Assembly (91) near the Right Handrail (54). Touch the Right Handrail to dis- 4 charge any static. 91
  • Weslo Cadence M6 | Uk Manual - Page 8
    lower the Handrails (53, 54) until they 7 are touching the floor. See the lower drawing. Position the Handrails (53, 54) so that the treadmill Frame (51) is centered between the Handrails. Firmly tighten the four Handrail Bolts (2) and the two Frame Pivot Bolts (1). Be careful not to overtighten
  • Weslo Cadence M6 | Uk Manual - Page 9
    Screws (7). Make sure that the Latch Assembly is oriented as shown. 53 7 48 9. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 18). To protect the floor
  • Weslo Cadence M6 | Uk Manual - Page 10
    cord into an appropriate outlet that is properly installed and earthed in accordance with all local codes and 3 ordinances. Important: The treadmill is not compatible with GFCI-equipped outlets. Outlet IT GR DANGER: Improper connection of the equipment-earthing conductor can result in an
  • Weslo Cadence M6 | Uk Manual - Page 11
    your workouts more effective. While the manual mode of the console is selected, the speed and incline of the treadmill can be changed with the touch speed programs. Each program automatically controls the speed of the treadmill as it guides you through an effective workout. To prevent damage to the
  • Weslo Cadence M6 | Uk Manual - Page 12
    2 Select the manual mode. When the key is inserted, the manual mode will be selected. If you have selected a speed program, reselect the manual mode by pressing of 400 meters (1/4 mile). As you walk or run on the treadmill, the indicators around the track will appear in succession until the entire
  • Weslo Cadence M6 | Uk Manual - Page 13
    To reset the displays, press the Stop button, remove the key, and then reinsert the key. Note: The console can display speed and distance in either kilometers or miles. To see which unit of measurement is selected, first remove the key, hold down the Stop button, and then reinsert the key into the
  • Weslo Cadence M6 | Uk Manual - Page 14
    setting is too high or too low during the program, you can manually override the setting by pressing the Speed buttons. However, when the next the program. Hold the handrails and begin walking. 4 Change the incline of the treadmill as desired. See step 4 on page 12. 5 Follow your progress with
  • Weslo Cadence M6 | Uk Manual - Page 15
    to safely lift 20 kg (45 lbs.) to raise, lower, or move the treadmill. 1. Hold the metal frame firmly in the location shown by the arrow at the position. Frame 2. Move your right hand to the position shown and hold the treadmill firmly. Using your left hand, pull the latch knob to the left and hold
  • Weslo Cadence M6 | Uk Manual - Page 16
    USE 1. Hold the upper end of the treadmill with your right hand as shown. Using your left hand, pull the latch knob to the left and hold it. Next, lower the frame until
  • Weslo Cadence M6 | Uk Manual - Page 17
    MAINTENANCE AND TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on SOLUTION: a. Make sure
  • Weslo Cadence M6 | Uk Manual - Page 18
    power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened. b 5-7cm Rear Roller Bolts c. If the walking belt still slows when walked on, please see the front cover of this manual. PROBLEM: The walking belt is off-center or slips when
  • Weslo Cadence M6 | Uk Manual - Page 19
    found by using your heart rate as a guide. The chart below shows recommended heart rates for exercise, adjust the speed and incline of the treadmill until your heart rate is near the highest number your muscles and will help prevent postexercise problems. EXERCISE FREQUENCY To maintain or improve
  • Weslo Cadence M6 | Uk Manual - Page 20
    4 Bolt (120)-2 PART IDENTIFICATION CHART Remove this chart and use it to identify small parts during assembly. Save this chart and the EXPLODED DRAWING/PART LIST for future reference. Handrail Washer/ Frame Washer (14)-6 Handrail Star Washer (9)-2 Crossbar Star Washer (12)-2 Nut (16)-4 Console
  • Weslo Cadence M6 | Uk Manual - Page 21
    Catch 27 2 Walking Platform 65 1 Hood Bolt, Rear 66 1 Belly Pan 28 4 Belt Guide Screw 67 1 Left Foot Rail 29 2 Rear Roller Adj. Bolt 68 1 Right Foot Rail White Wire, 2F 10" White Wire, 2F User's Manual #These parts are not illustrated. Specifications are subject to change without notice.
  • Weslo Cadence M6 | Uk Manual - Page 22
    30 34 73 38 87 44 72 25 38 59 34 21 23 42 79 40 25 67 25 41 94 97 21 46 83 77 62 33 45 56 96 49 88 31 105 25 41 64 50 78 41 25 95 28 71 22 25 37 45 33 68 27 85 19 21 42 60 36 29 74 46 6 17 18 32 13 43 106 25 25 76 86 21 42 55 19 27 29 74 61 36 41 46 69
  • Weslo Cadence M6 | Uk Manual - Page 23
    , Ltd. office, or write: ICON Health & Fitness, Ltd. Customer Service Department Unit 4, Revie Road Industrial Estate Revie Road Beeston Leeds, LS118JG UK the NAME of the product (WESLO CADENCE M6 treadmill) • the SERIAL NUMBER of the product (see the front cover of this manual) • the KEY NUMBER and
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23

USER'S MANUAL
Serial Number
Decal
Model No. WETL13706.0
Serial No.
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
for future reference.
QUESTIONS?
As a manufacturer, we are com-
mitted to providing complete
customer satisfaction. If you
have questions, or if there are
missing or damaged parts,
please call:
or write:
ICON Health & Fitness, Ltd.
Customer Service Department
Unit 4
Revie Road Industrial Estate
Revie Road
Beeston
Leeds, LS118JG
UK
08457 089 009